Re: Text flow across non-contuguous sections

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance


You can't. Text can't flow over a section break. You may find it most satisfactory not to insert the diagram until text editing is complete.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA
http://word.mvps.org

"Tom R" <Tom R@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message news:573E9306-A479-43E0-A4C8-00BCE2562E47@xxxxxxxxxxxxxxxx
In a word document I have three sections. In the first and third section I
want continuous text to flow. In Section 2 I have a diagram. How can I have
my text automatically continue from section 1 to Section 3 as I make changes.


.

Relevant Pages

  • Re: Xilinx Schematic Entry
    ... Slurp's great-looking example was mostly data flow ... back when I was doing schematics I was using wrappers around flip-flops and gates that looked like state diagram elements. ... It made for a very quick (in terms of schematic entry time) entry and easy to understand schematics. ...
    (comp.arch.fpga)
  • Re: bbc four - the secret life of the motorway
    ... A circuit diagram is a flow chart which indicates the ... figure out form his tube map whether you need to travel North, South, ...
    (uk.media.tv.misc)
  • Re: Bidirectional DCDC Converter
    ... Tom M wrote: ... i make a full-bridge DCDC boost converter i could replace the rectifiers on the secondaray side with MOSFETS and use them as diodes to allow the current to flow from the source to the storage device. ... Then reverse the opration and the power could flow from the storage device to the source again. ... I have a few small planar forward SMPS sitting in front of me that use synchronous rectification (FETs instead of diodes). ...
    (sci.electronics.design)
  • Re: How do I get text to flow around a section?
    ... A section break stops all text flow. ... Word MVP FAQ site: http://word.mvps.org ... > diagram into this section. ...
    (microsoft.public.word.pagelayout)
  • Re: ** calculation of mass-flow from volumic-flow **
    ... I basically agree with Tom Sanderson. ... You need the density of the fuel to convert volume flow ... flow rates and liquid viscosities over which the reading ...
    (sci.mech.fluids)