Can't download image through etherNet.
- From: "shinewine via PocketPCJunkies.com" <u42142@uwe>
- Date: Wed, 24 Sep 2008 02:24:18 GMT
Hello Friends...
I am working in WinCE 5.0 and want to dwnload image through ethernet to
board but when i download the eboot.nb0 file and run it. After setting the
ip, subnet and Mac address when i press the option "D" (for download image by
ethernet) the DNW window shows the all the message correctly.
The DNW messages are given below..
System ready!
Preparing for download......
using device name: 'SMDK24401286'
+EbootSendBootmeAndWaitForTftp
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
............................................
............................................
..............................................
-------------------------------------------------------------------------
In the plateform builder
Target ->Connectivity Options I set the following Settings.
target Device = CE Device
Download = Ethernet
Transport = Ethernet
Debugger = None ( i also try "KdStub")
the " Core Service Settings" are ...
Download Image = Always
KITL Settings = All three are checked.
in the service Status ....
in the "Status" column
Waiting is shown in all the rows.
and finally in the Target -> Attach Device.. window
Estimate time left = waiting for BOOTME from CE Device
Download through = Ethernet
Transfer rate = 0KB/sec
i am working in SMDK2440 BSP.
can anybody help/guide me .
waiting for reply....
Thank you to all of you.
--
M.Zubair
Message posted via http://www.pocketpcjunkies.com
.
- Follow-Ups:
- Prev by Date: Re: Vendor has x86 driver, am I asking for too much for ARM version?
- Next by Date: Re: Clone component libraries (CalibrUi) problem
- Previous by thread: Vendor has x86 driver, am I asking for too much for ARM version?
- Next by thread: Re: Can't download image through etherNet.
- Index(es):
Relevant Pages
|
