Re: Downloading nk.bin to Target device without PB?

Hi

Is it true that downloading kernel image using Trival FTP is faster than PB?
The connection is should be using Ethernet connection.
The link below is the correct TFTP server download?
http://www.download.com/Quick-Tftp-Server-Pro/3000-2085_4-10483017.html.

I believe the microP have the ethernet module internally and the PCB routed
this pins to the external ethernet connector. Anyone knows how is the
connection like?

alvin


--


Thanks
Alvin


"gouri" wrote:

Thank u very much to Henrik Viklund and Anthony Pellerin.

Anthony Pellerin where can i get the eshell.exe.I tried out with Pumpkin.exe
it is downloading without PB.But i want to use eshell.exe.Please help me in
this regard.

Thanks,
Gouri

"Henrik Viklund" wrote:

Anyone you like that can be set to port 980 (like for example tftpd32).
One more thing, though, you need to rename "nk.bin" to "boot.bin"
because that's the filename the bootloader tftp server expects to be
"put". Note that the bootloader implements a tftp *server*, so you
should use a tftp client on the host.

Henrik Viklund
http://www.addlogic.se

gouri wrote:
Thanks! That sounds exactly like what I want to do. which TFTP client i have
to
use and how was it setup?

Thanks,
Gouri
"Henrik Viklund" wrote:

One alternative is to use a TFTP client to download the image. PB
download use a slightly modified TFTP protocol (it uses port 980 rather
than port 69), so you can use a TFTP client set to port 980 on the host
pc for the download. If you want the image to launch after download you
need to modify the bootloader to immediately jump to the image rather
than wait for a PB "jump" control command.

Henrik Viklund
http://www.addlogic.se

gouri wrote:
Hello,

I would like to download the nk.bin file to the target device without the
use of Platform Builder. I am working on PXA 27X and BSP is Mainstone II
.Does anyone know just exactly how that could be
accomplished?


Any help would be greatly appreciated.


Thanks,
gouri




.

Relevant Pages

  • Re: Downloading nk.bin to Target device without PB?
    ... And how to download the nk.bin to the on board Flash? ... The link below is the correct TFTP server download? ... "gouri" wrote: ... "Henrik Viklund" wrote: ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Downloading nk.bin to Target device without PB?
    ... Could i TFTP out the nk.bin that is residing in the Flash memory? ... The link below is the correct TFTP server download? ... "gouri" wrote: ... "Henrik Viklund" wrote: ...
    (microsoft.public.windowsce.platbuilder)
  • Re: installing driver problem
    ... Download the driver from the OEM site, whether it be HP, Dell, or wherever, not MS Updates. ... I did use this ethernet connection before, but had to use the restore disk and now I've got this problem. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: cannot download nk.bin
    ... and written the bootloader into flash. ... platform builder to download the image. ... the ethernet connection (in this case you should check that the device ... start the download (check that there is no personal firewall ...
    (microsoft.public.windowsce.platbuilder)
  • Re: ethernet connection
    ... nk.bin from the host. ... code for initializing eth h/w and deciding to download the nk.bin file from ... > through Ethernet connection.since i can't use BootableFloppy, ... > Can anyone help in getting the image through this ethernet connection? ...
    (microsoft.public.windowsce.embedded)