Re: Build Error!!!!!

Tech-Archive recommends: Fix windows errors by optimizing your registry

Only you can tell us if you need to modify your config.bib, or if it is set
up to support an environment variable. But clearly that message is telling
that the current settings, which are set in config.bib, are not correct.

--
Bruce Eitman (eMVP)
Senior Engineer
beitman AT applieddata DOT net

Applied Data Systems
www.applieddata.net
An ISO 9001:2000 Registered Company
Microsoft WEP Gold-level Member

"Mekas" <Mekas@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:ACD149D4-5984-45FF-BEC1-47F9244A8B65@xxxxxxxxxxxxxxxx
Hi,

I just build the Sample OMAP2420 bsp (H4Sample) in debug build. I got some
errors in makeimage. But when i build in release build error is not
coming.
But in other system, i built. No errors are coming in both debug and
release
configurations.

The following are some part of build errors in makeimage phase..

PREROMIMAGE processing...

makeimg: run command: romimage
F:\WINCE600\OSDesigns\OMAP2420\RelDir\H4Sample_ARMV4I_Debug\ce.bib

Windows CE ROM Image Builder v4.0.000 Copyright (c) Microsoft Corporation
Built: Jul 25 2006 16:36:51

Q flag encountered, adding module k.toolhelp.dll
Q flag encountered, adding module k.prnport.dll
Q flag encountered, adding module k.prnerr.dll
Q flag encountered, adding module k.ceddk.dll
Q flag encountered, adding module k.ws2.dll
Q flag encountered, adding module k.wspm.dll
Q flag encountered, adding module k.nspm.dll
Q flag encountered, adding module k.ssllsp.dll
Q flag encountered, adding module k.schannel.dll
Q flag encountered, adding module k.dhcpsrv.dll
Q flag encountered, adding module k.mmtimer.dll
.
.
.
Pass 1...

Warning: Unable to do imports from ppp.dll to RSAENH.dll - will late bind
Warning: Unable to do imports from schannel.dll to RSAENH.dll - will late
bind
Warning: Unable to do imports from k.schannel.dll to RSAENH.dll - will
late
bind
Warning: Unable to do imports from eapol.dll to RSAENH.dll - will late
bind
Warning: Unable to do imports from eapchap.dll to RSAENH.dll - will late
bind
Warning: Unable to do imports from crypt32.dll to RSAENH.dll - will late
bind
Warning: Unable to do imports from k.crypt32.dll to RSAENH.dll - will late
bind
Warning: FixupVar module not defined for gdwFailPowerPaging, assuming
kernel.Warning: Module for FixupVar gdwFailPowerPaging not found.
Variable
not fixed up.

Pass 2...

RAM AutoSize: RAM Start=86990000 RAM Size=ff670000
Error: Image is too large for current RAM and RAMIMAGE settings
The default end address of RAM was exceeded.
Fatal error hit, exiting...
makeimg: FATAL ERROR: Command returned non-zero exit code 1 (dec).
makeimg: FATAL ERROR: Command returned non-zero exit code 1 (dec).
------------

I've enabled " Runtime image larger than 32MB". It seems that RAM is not
is
not sufficient. But i didnt change anything.

Anybody come across this error. Whether i've to modify config.bib?

Regards,
kumar






.

Relevant Pages