Re: Via CN700 board porting....

Hello Daniel,


"daniel" <daniel@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message news:C77649D4-B58A-42CD-8EC7-5FFA7365C059@xxxxxxxxxxxxxxxx
hi,
I have been trying to port ce 5.0 (6.0) to my via board.
The chipset is CN700 + VT8237R and via provides a bsp for the assembly.
In my understand, the 8237r has built in ethernet MAC component in it. But
my board seems not to use the built in module but use external ethernet
controller RTL8100C.

Do you know your board actually has it ? In my experience there were several CN700-based boards, all with VT8237R chip on them, but none had that built in VIA ethernet controller ( VIA Rhine it is called). If that's what you mean by "built in ethernet MAC component".

Sergei R

Unfortunately, realtek doesn't provide a ce driver for 8100C.
Then I can't use the ethernet function at ce os?
Is there any way to work the 8100C chipset within CE ?
I tried to port it by adding 8139 driver to os design but it even can't boot
well.


.

Relevant Pages

  • Re: Connecting Vortex86 - 6072
    ... think that this port is reserved for debugging. ... Override Serial Driver: serial dirve debug output selected on COM port ... I have successfully built an image with WIndows Embedded 6.0, ... The device has no Ethernet capability - only serial and host USB. ...
    (microsoft.public.windowsce.platbuilder)
  • Very Slow v440 100 Meg Network Interface ce0
    ... seeing loads of runts on the Cisco switch between source and v440 ... Port AuxiliaryVlan AuxVlan-Status InlinePowered PowerAllocated ... I am aware that runts are "<64 bit ethernet packets that are too short ... packets errs packets errs colls packets errs packets errs colls ...
    (SunManagers)
  • Re: Connecting Vortex86 - 6072
    ... shouldn't be *required* to do it to get a KITL connection working. ... I guess I will have to setup an Ethernet connection to the board... ... configured to do that, hence, no download of OS image or anything else. ... Turning on KITL and setting the port to the same port as where ...
    (microsoft.public.windowsce.platbuilder)
  • RE: Ethernet tap vs. spanned port
    ... be replicated to the destination SPAN port. ... Ethernet tap vs. spanned port ... attacks with snort but not with etrust it could be that snort does not ...
    (Focus-IDS)
  • Re: Connecting Vortex86 - 6072
    ... I guess I will have to setup an Ethernet connection to the board... ... even if kernel debugging is not turned on. ... downloads, but, based on this message, "Override Serial Driver: No COM port ... configured to do that, hence, no download of OS image or anything else. ...
    (microsoft.public.windowsce.platbuilder)