Re: CEPC Does not recognize Hard Drive
- From: Valter Minute <v_a_l_t_e_r.m_i_n_u_t_e@xxxxxxxxxxxxx>
- Date: Thu, 26 Jul 2007 01:08:11 -0700
=?Utf-8?B?YmhhdmFuaQ==?= <bhavani@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote
in news:7EAE5BF2-BCAB-4583-82FE-73F159B70196@xxxxxxxxxxxxx:
Hi Valter,
Thanks for the reply. The hard disk is recognised by the BIOS. The
disk is attached to primary channel & it's jumpers are set
correctly.
Below is a part of debug messages.
It seems that the IDE driver is not loaded (or it was hidden inside
the mess that my newsreader generated by word-wrapping your log...).
Did you include the "ATAPI PCI/IDE storage block driver" in your OS
image?
Do you have PCI-to-PCI bridges or other "strange" PCI configurations
on your device?
Is the IDE controller PCI-based?
You may try to enable the debug zones of your PCI bus driver to
check if your ide controller is recognized and why no drivers are
loaded for it.
You may use PCISNIF or other DOS-based utilities to check if your
controller is recognized correctly.
--
Valter Minute
(the reply address of this message is invalid)
(l'indirizzo di reply di questo messaggio non è valido)
.
- References:
- Re: CEPC Does not recognize Hard Drive
- From: Valter Minute
- Re: CEPC Does not recognize Hard Drive
- From: bhavani
- Re: CEPC Does not recognize Hard Drive
- Prev by Date: Re: Files in RAM
- Next by Date: Re: USBD unable to load USBMSC.DLL for Mass storage Device.
- Previous by thread: Re: CEPC Does not recognize Hard Drive
- Next by thread: Re: CEPC Does not recognize Hard Drive
- Index(es):
Relevant Pages
|
