[WinCE 5.0] Attaching Device over Ethernet get disconnected at the end?

Tech-Archive recommends: Speed Up your PC by fixing your registry

Hi All,

I am using Intel PXA27 development board, Initially I configure the
board with Eboot.nbo provide by Intel for the board to execept image
downloading over ethernet .. The ethernet port get the ip address and
it under receicve BootMe state ..... After this I open the Platform
builder set the cionnectivity settings for ethernet, i sucessfully
gets the board name and ip in settings. i save the settins and do
Target->Attached Device..
The OS image starts downloading but once the image gets downloaded
100% the debug window shows message "device disonnected sucessfully"
and everythinbg stops ... And wince OS doesnt boot up at the
board ...
It will e very helpful if some body can throw any light on this
problem.

Thanks and regards
Abdulkadir....

.

Relevant Pages

  • Re: Cable Modem / Internet / Built-in 10-100 Ethernet / Slows & Then Stalls...
    ... when surfing its okay, however, when downloading like new iso image ... for a device that connects via ethernet you have an MTU ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ...
    (Debian-User)
  • Re: Need help in completing the CEPC Tutorial
    ... Normal settings would be Ethernet, Ethernet, KdStub. ... Also while your device is booting choose Settings and wait for the device name to appear in the list box. ... Then select that name and try downloading again. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: IE hanging
    ... he says it was a Rhine Ethernet update. ... That's the VIA Ethernet NIC Adaptor. ... Do you use that Ethernet Connection for your Internet Connection? ... But then I know many people do end up Downloading & Installing loads ...
    (uk.people.silversurfers)
  • RE: SBOOT launch problem
    ... The launch process after downloading the image should be exactly the same ... as it is when you download over Ethernet. ... similar to the Lubbock bootloader, you need to flush the caches, disable ... and jump to the physical start address of the nk.bin image. ...
    (microsoft.public.windowsce.platbuilder)