Re: PxA27x Display Driver 24BPP support

Tech-Archive recommends: Fix windows errors by optimizing your registry


Double check the timings, clocks etc. Also are
there any other peripherals intensively used?
While this may look not related, but what else
do you have on the board?


Anurag wrote:
Hello Voidcoder,

Thankyou for the reply and yes also for forwarding the link.
I have chosen conversion from 32bpp to 18bpp. The conversion seems to have happen well, the desktop can be seen however i see a lot of flickers on the LCD.
I am using TFT QVGA Display.
320 * 240
32 BPP.

Could you help me sort out the issue.

Regards,
Ann



"voidcoder" wrote:

You may want to check the following post by
Mike Calligaro before to start:

http://blogs.msdn.com/windowsmobile/archive/2005/09/07/462187.aspx

My own opinion is that any solution to get 18bpp
mode working on PXA (except of supported by the LCD
controller 8-to-18bpp hardware color lookup)
will lead to a good performance lost...


Anurag wrote:
Hello Everybody,

We are using the available LQ057Q3DC02 Display Driver(WINCE500\PUBLIC\COMMON\OAK\CSP\ARM\INTEL\PXA27X\DISPLAY\PXA27X_LCD).

The driver implementations are for 16 bpp and has no support for 24 BPP i.e., the Gwes supports 24 Bpp support but the existing Driver does not have support for the same.

Our hardware supports 18BPP and we plan to convert the 24bpp to 18bpp.

Could someone guide us how to incorporate the 24 BPP support in the existing display driver.


Thankyou,
Ann

.

Relevant Pages

  • Re: Dynamic display resolution change in CE 6.0
    ... I have looked a bit at the RageXL driver, and there are some places where that driver does special handling for the case of changing the display resolution. ... I will try to add this support by intercepting changes to the display mode ), and then manually deleting and reallocating the primary surface. ... "Michel Verhagen (eMVP)" wrote: ...
    (microsoft.public.windowsce.platbuilder)
  • [PATCH/RFC 2.6.20-rc4 1/1] fbdev,mm: hecuba/E-Ink fbdev driver
    ... This patch adds support for the Hecuba/E-Ink display with deferred IO. ... This is the frame buffer device driver for the Intel-based Macintosh ...
    (Linux-Kernel)
  • Re: wince 5.0 cepc download problem
    ... > ethernet controller and 5.0 has no ethernet driver support for it ... > that display adapter is also of intel and 5.0 again has no display ... adapter support VESA compatible video modes. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: PxA27x Display Driver 24BPP support
    ... The LCD controller has been configured as 18 bpp. ... The clocks at the LCD controller level seem to fine fine. ... The driver implementations are for 16 bpp and has no support for 24 BPP i.e., the Gwes supports 24 Bpp support but the existing Driver does not have support for the same. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: 30" monitor and what video card?
    ... So long as it has a dual-link DVI connector, it will support 30" ... What has me still scratching my head is that when I 'enable all display modes', ... even the ones not supported by your monitor' the NVidia display applet only ... But sans a a fixed driver, ...
    (comp.sys.ibm.pc.hardware.video)