Re: How to enable debug output for eboot.nb0?

The solution to this is going to be very specific to your boot loader. It
could be that the serial port is not enabled until just before jumping to
the nk.bin.

--
Bruce Eitman (eMVP)
Senior Engineer
beitman AT applieddata DOT net

Applied Data Systems
www.applieddata.net
An ISO 9001:2000 Registered Company
Microsoft WEP Gold-level Member

"RFOG" <zephryn.xirdal@xxxxxxxxxxxxxxxxx> wrote in message
news:op.thvgh8keba17y4@xxxxxxxxxxx
Hello all.

My old eboot.nb0 showed a lot of debug strings into debug serial port, but
my new eboot build does not. eboot.nb0 works fine, and boots machine ok,
but it only says on serial port:

SBTF1234ORX
JUMP

and nothing more.

I've tested a debug build, but it does not say more, and source code is
full of EdbgOutputDebugString...

Any help, please?
--
Visita mi blog: http://rfog.blogsome.com
Libros, ciencia ficción y programación
========================================
A donde fueres haz lo que vieres.
-- Refrán.


.

Relevant Pages

  • Re: Ecos, LwIP, PPP and GPRS
    ... the modem has an IP stack built in. ... FTP is the most important right now. ... >>while printing the messages over another serial port. ... >Can you modify the debug output to go to a memory buffer instead of the ...
    (comp.arch.embedded)
  • Re: Debug serial port
    ... the serial port has been closed. ... >> void OEMInitDebugSerialKernel ... >>> beitman AT applieddata DOT net ... >>> Applied Data Systems ...
    (microsoft.public.windowsce.platbuilder)
  • How do I redirect debug messages to the serial port? (debugging 91c96 lan ISR routines on pxa255, PB
    ... like to get some debug information out of the ISR routines. ... messages would be redirected to the serial port if KITL was disabled. ... Debug Build with KITL turned off, Kernel Debugging turned off (and ... There was a suggestion to include the ethernet debugging libraries ...
    (microsoft.public.windowsce.platbuilder)
  • Re: COM3 on X86 Platfom
    ... registry and match the BIOS. ... Are you using a serial port for debug? ... I checked them with a registry ... Build a debug image and set a breakpoint in the Init function of the ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Readfile 0 byte from serial byte
    ... beitman AT applieddata DOT net ... > I got a strange problem that I read 0 bytes from a serial port on Win CE ... > DCB dcb; ...
    (microsoft.public.windowsce.embedded.vc)