Re: Connectivity problem with PB 5.0

Well, what does the trace output show? Can you see any
output from the serial port during the boot phase?


"Stefano Magni" <StefanoMagni@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:3B6EC015-4169-48C4-9B3A-C0D6EC13F7F1@xxxxxxxxxxxxxxxx
Yes, in the Settings/Build Options dialog there are checked only "Enable
Eboot Space in memory" and "Enable Full Kernel Mode".
This appened when I create a platform with "Via ProSavage/Twister CEPC"
support; if I create platform with "CEPC X86", after press "Connect device"
operative system run correctly.

"Voidcoder" wrote:

Make sure KITL/KDBG are both disabled
(check Platform Settings) if you don't need
debugging, or both enabled otherwise. Also
for debugging you will need to setup
"Debugger: KdStub" in the Connectivity
Options dialog.



"Stefano Magni" <StefanoMagni@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:D0F0C27E-8950-495D-A02A-644098F0B085@xxxxxxxxxxxxxxxx
hi all,
I've generated my platform thougth BSP of ViaArena. IF startup my device
with boot disk, thougth PB (Attach device function), the upload procedure of
NK.bin run correctly but operative system don't start. Why ?
If I put the same NK.bin generated in my CompactFlash and reeboot, operative
system start correctly.

thanks
stefano





.