Re: Display problem! cant set 16bpp...

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

Hi,
Thanks for answer. In fact i dont know hot to dump registry. Could you
please explain?

"Voidcoder" <voidcoder@xxxxxxxxx>, haber iletisinde sunlari
yazdi:eVDmC2kIGHA.668@xxxxxxxxxxxxxxxxxxxxxxx
> Try to dump registry on prebuilt image and
> compare vs. your platform.reg (or better reinit.ini).
> See if there are some differences for the
> AFD, PPP and display drivers.
>
>
>
> "CAGRI" <arge5@xxxxxxxxxxxx> wrote in message
> news:OliUlfkIGHA.216@xxxxxxxxxxxxxxxxxxxxxxx
>> Hi,
>> I got ICOP Vortex86 6071 board and winCE 5.0 plat builder and using AUO
>> 12.1 inch (800x600 tft lcd) panel.
>> When i m using the pre-built image that i downloaded from icop's web
>> site, the display is very well. I m following serial debug outbut from
>> hyperterminal and it says:
>> "
>> VGAMode: ModeID:47, ModeIndex:1, RateIndex=2
>> VGAMode: X:800, Y:600 ,Bpp:16, Refresh Rate:60
>> "
>>
>> So I have built the image as following instructions in Step by Step or
>> Starter Guide like manuals by writing propriate registery entries for
>> 800x600x16 VSync:60Hz.When i load the image(by biosloader) the debug
>> output :
>>
>> "
>> SysInit: Mapping Extra RAM from 0x84000000 to 0x87000000
>> GDTBase=817b50e8 IDTBase=817d6860 KData=817dd800
>> Windows CE Kernel for i486 Built on Jun 24 2004 at 18:23:42
>> g_pPageDir = 817e0000 X86Init done, OEMAddressTable = 817e1000.
>> DeviceFolder::LoadDevice!Enumerate Found deprecated load instructions
>> at (Driver
>> s\BuiltIn\AFD). Driver cannot be unloaded.
>> DeviceFolder::LoadDevice!Enumerate Found deprecated load instructions
>> at (Drivers\BuiltIn\PPP). Driver cannot be unloaded.
>> CalibrateStallCounter: delay is 62
>> Get Mode info from /L Args->VideoMode=0!! cx=800, cy=600!!
>> VGAMode:
>> ModeID:47,
>> ModeIndex:1, RateIndex=2
>> VGAMode: X:800, Y:600 ,Bpp:16, Refresh Rate:60
>> SYSAGP:Reserved memory use registry setting!!
>> Address:80220000 Size:00300000
>> Lyg.p: Layout Manager successfully
>> initialized to 1
>> Explorer(V2.0) taskbar thread started.
>> NDISPWR:: Found adapter [PCI\RTL81391]
>> "
>> I can see:
>> VGAMode: X:800, Y:600 ,Bpp:16, Refresh Rate:60
>> in my image too. Although the resolution seems ok on screen, the color
>> depth is not! It seems like 8bpp instead of 16bpp.
>> I also couldnt figure out "Driver cannot be unloaded" messages.
>> What could be the display's ploblem and what it means that messages?
>> Any comment would be nice,
>> Thanks in advance...
>> -CAGRI-
>>
>>
>
>


.