Re: Downloading the boot loader to the S3C2410TK board

Are you sure none of the switch has been changed on the board ? There is so
much of them (if it is the same as the SDMK2410 board) that it is easy to
have a bad configuration.
Make sure you have the good type of boot selected (NOR16/NOR32/NAND), make
sure the USB device connector is really configure as a USB device.
Or maybe the content of the flash has been corrupted for any reason. In this
case, you'll probably have use a JTAG to run you EBOOT from RAM and then
flash it.
HTH

--
----------------------------------------------------------------
Anthony Pellerin
ADENEO (ADESET)
Windows Embedded Consultant
<apellerin AT adeneo DOT adetelgroup DOT com>
http://www.adeneo.adetelgroup.com
Tél : +33 (0)4.72.18.57.77
Fax : +33 (0)4.72.18.57.78
----------------------------------------------------------------


"tam" <ayytam@xxxxxxxxx> wrote in message
news:1137464914.542921.85420@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Hi all,
>
> I am using S32410TK board and the image is built using the SMDK2410 BSP
> included in the Platform Builder. I have followed the step to download
> the boot loader to the board. It can go to the boot menu for so long.
> But starting from yesterday, I found that when I switched on the board,
> it cannot go to the boot menu anymore. The hyperterminal window
> displayed nothing. I don't know what's wrong with it....... Afterwards,
> I have tried to use USB to download the boot loader. However, my PC
> can't detect the USB device (the board). Then, I have tried to
> re-installed the USB driver (secbulk.inf) but my PC say the hardware
> does not match.....
>
> Can anyone have this problem before? I really don't have any idea on
> that. Please help me.
> Many thanks.
>


.

Relevant Pages

  • Re: Simple question- how to erase everything?
    ... Can you use a USB device to run the ... wipe prog from after you boot to the system? ... to boot to another device. ... but this is a rack machine so how do I do this (it's ...
    (alt.linux)
  • Re: [SLE] connect to cellphone
    ... USB device using ohci_hcd and address 9" when it is connected. ... telling me about how I might access the linux file system on the phone? ... If I boot linux ... site-wide spam filters at catherders.com. ...
    (SuSE)
  • detecting no USB device quickly
    ... When I boot a kernel on a system with a USB drive attached, ... time delay before that drive is available. ... a problem with is doing that waiting when there is no USB drive at all. ... USB device plugged in that is not yet completely registered (as opposed to ...
    (comp.os.linux.development.system)
  • Re: PC104 board boot off compact flash, load initrd, and execute out of ramdisk
    ... I think it can boot off a USB device although we are not using any USB ... stuff and therefore did not purchase the little pigtails that would go ... CF card shows up as /dev/hdc, however with a newer kernel a buddy gave ...
    (comp.os.linux.embedded)
  • Re: linux on a usb stick (no hard disk, cdrom,floppy)
    ... your bios to be capable of booting from a usb stick. ... stick, place a boot loader ... on the usb device (arrr ... ...
    (comp.os.linux.setup)