Re: Kernal Debug enabled cannot boot up CEPC

You need to start that from the IDE, typically done with the attach menu
item or toolbar button. It's possible the target communication settings are
disabling the debugger messages or more likely that a firewall or network
setting problem is getting in the way. (The IDE will look up the address it
is supposed to use based on the first network card in the network order. If
that's not the same network the device is connected to then it won't be able
to communicate)
--
Steve Maillet
EmbeddedFusion
www.EmbeddedFusion.com
smaillet at EmbeddedFusion dot com


.