Re: DEBUGMSG and FFUART enabled at the same time

Thankyou for your reply!
Yes, what you suggest is what I have done. When I look into the platform.reg
file generated in my release directory, I can see that the FFUART is
present, but the STUART (to be used for DEBUGMSG) is not, when set the
BSP_DBGSER_UART1=1 and not set BSP_NOSERIAL=.
So my feeling is that registry setting is OK. But as I previousely indicated
debug does not work with this setting.

Looking into configurations for other boards, it seems to be several Serial
Device Drivers under the Workspace-Feature tab. Actually one for each serial
port in use. I have only the default one accompanied by the Intel Lubbock
configuration: Serial => XSC1BD Serial.
Could this be my problem and if so what do I have to do?

Looking forward for some good advices!
/trond
"Steve Maillet (eMVP)" <nospam1@xxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:%23W25cssYFHA.3616@xxxxxxxxxxxxxxxxxxxxxxx
> Just manually change your platform.reg to use one of the ports all the
time
> and the other dependent on the DEBUG UART setting.
>
> --
> Steve Maillet
> EmbeddedFusion
> www.EmbeddedFusion.com
> smaillet at EmbeddedFusion dot com
>
>


.

Relevant Pages

  • Re: Shared /usr/ports directories
    ... Where configurations get saved can vary slightly. ... >>That way all the files that are created when you build a port ends up ... Another options is to download all the distfiles in advance to the ... > I usually do a 'make install clean' anyway, but it would be good to be ...
    (freebsd-questions)
  • I just installed pf on a new server w/current and nat doesnt seem to work.
    ... My configurations follow. ... pass in on $ext_if inet proto udp from any to port ... pass in on $int_if inet proto tcp from any to 127.0.0.1 port 3128 keep state ...
    (freebsd-current)
  • configuration of silkworm 3800
    ... machine are connected to the silkworm switch,still sun machine can not ... We have configured a zone in the switch which includes port 0 ... and port1 and those array and the machine is connected to those ... Is there any other configurations to be done? ...
    (SunManagers)
  • Re: Bind service to a particular ethernet device
    ... Ignacio Garcia said: ... >I would like to run two instances (with different configurations) of a ... >service that runs on a specific port (and I must use that specific port ... "...cancel my subscription to the resurrection!" ...
    (comp.os.linux.networking)
  • Re: How to simulate Platform builder download image to a wince device?
    ... basically an extended tftp on a different port number. ... Steve Maillet ... smaillet at EmbeddedFusion dot com ...
    (microsoft.public.windowsce.embedded)