DEBUGMSG and FFUART enabled at the same time

Hallo!

I have two fully operational serial ports (FFUART and STUART) on my
XSCALE-device. I can use both at the same time from my application.
Now I would like to have one of my ports supporting the DEBUGMSG command.
The only way I have managed to do this is by setting BSP_NOSERIAL=1 (no
serial port) and BSP_DBGSER_UART1=1.This unfortunately disables all serial
ports except the DEBUG-port. Debugg messages is displayed on my STUART.

Why am I not able to enable one port for DEBUGMSG and FFUART for my
application at the same time?
Any idrea is welcome since I feel I have tried all possibilities!

/trond


.

Relevant Pages

  • Re: 1-wire to USB converter that can use 1820s directly
    ... than to need to add another PCI card to support serial ports. ... how someone could finally say "not one more f'ing wire!" ...
    (comp.home.automation)
  • Re: remote access KVM switch
    ... ->>seen so many Lightwave KVM switches around in server rooms. ... Some console servers even allow ssh access. ... -> very sophisticated, but it has 30 serial ports, telnet ...
    (comp.sys.sun.admin)
  • Re: How 2 connect old computer db9 port to new laptop with db15 or usb
    ... All serial ports are male (the pins ... has a DB9 male port and my new laptop has a DB15 male port and usb ports. ... Support for Flash drives and USB connected hard drives in Windows 98 ...
    (microsoft.public.windowsxp.hardware)
  • Re: Late to the party: Whats Rosetta?
    ... will have 5 full duplex serial ports, two TTL ports and one pin that can be ... The ZX-24 firmware can be updated over the serial link. ... The other four serial ports are 9600 MAX and will understand the ... communications protocols for the CM11A, CPU/XA, Ocelot, Leopard, Smarthome ...
    (comp.home.automation)
  • Re: Sun Microsystems Enterprise 3500 server
    ... are 5 ethernet ports to choose from. ... the same board that has the serial ports A & B. And there is another ... bottom of the front panel are an MII connector (ethernet which I have ... possibly Fibre Channel intterfaces called OLC j0 and OLC 1). ...
    (comp.sys.sun.hardware)