Re: CEPC stuck at DHCP

I tried removing USB-related items from the catalog, disable USB in the BIOS
and switching to a RTL8139D-based PCI ethernet card. But the problem is
still there.


"winfresh" <winfresh@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:90AE3707-1A11-46B8-BE63-235C255FB551@xxxxxxxxxxxxxxxx
> i think u need to remove the USB driver from ur catalog.
> It gives problem for CEPC download.
>
> "Soh Kok Hong" wrote:
>
> > Hi all,
> >
> > I tried to create a CEPC platform based on an old Pentium 3 PC with a
3Com
> > 3c90x Ethernet interface. I had used the CEPCBOOT.144 utility to create
the
> > boot diskette. The PC was booted up with the default
> > config.sys/autoexec.bat options. The ethernet interface was correctly
> > identified by loadcepc as a 3Com 3c90x ethernet interface but eboot.bin
> > failed in trying to obtain an IP address via DHCP with the message:
> >
> > ProcessDHCP()::DHCP_INIT
> >
> > I sniffed the ethernet interface to verify that the CEPC was not sending
out
> > any packets at all.
> >
> > I had also tried to assign a static IP address to see if the CEPC would
> > contact my development machine with BOOTME requests. Again, I did not
> > detect any packets coming from the CEPC.
> >
> > Does anyone know what could be the problem?
> >
> >
> >
> >


.

Relevant Pages

  • Re: eboot failure!!! and image loading failed
    ... same .The board has realtek 8110SB as an integrated ethernet card.When i ... It is clear here that the ethernet card is getting detected,but it is not ... Also if i try to boot from the hard disk(i am using x86 bootloader),i ... I am able to load a cepc image ...
    (microsoft.public.windowsce.platbuilder)
  • CE4.1 CEPC debugging
    ... I created an CEPE image, and could upload it via ethernet, ... but I could not establish the connection between the CEPC and a PB. ... Are their any special configuration needed for enabling debug connection for ...
    (microsoft.public.windowsce.embedded)
  • dumping to 0x0013A388
    ... Based on the article from Microsoft Windows CE 5.0: "How to Add a CEPC ... to an Ethernet Network" ... Create a boot floppy disk for the CEPC ... What information should I add and modify for file Autoexec.bat? ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Arbor 612 Boot Message
    ... When you configure remote connection and choose ethernet, does the CEPC ... download does not begin, try to restart your CEPC as suggested in MSDN. ... "msnews.microsoft.com" ha scritto nel messaggio ...
    (microsoft.public.windowsce.platbuilder)
  • Re: PB 5.0 recording program?
    ... It has no corresponding catalog item. ... I create a CEPC CE5.0 image, I want to do a recording test. ... Every funtion in "Graphics and Multimedia" I tried and I still could ...
    (microsoft.public.windowsce.platbuilder)