Re: porting of image

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

From: Bruce Eitman \(eMVP\) (beitmannospam_at_NOSPAM_applieddata.NOSPAM_net)
Date: 02/25/05 

Date: Fri, 25 Feb 2005 13:09:58 -0500

You have given us very little information to assist you.

Do you have KITL enabled? If so, are you connecting with PB?
Are you getting any debug output on serial, if so, what it it? If not, you
need to do it. 

-- 
Bruce Eitman (eMVP)
Senior Engineer
beitman AT applieddata DOT net
Applied Data Systems
 www.applieddata.net
An ISO 9001:2000 Registered Company
Microsoft WEP Gold-level Member
"sabya" <sabya@discussions.microsoft.com> wrote in message
news:B1288759-D200-46CC-B45F-18AE9AFEFB37@microsoft.com...
> am porting my image to different machines from host to target. in one m/c
it
> is working but other systems it is not. what may be the trouble. it is not
> showing any error but after booting from flopy am getting the cepc number
but
> after that when i download am not getting any image in the target system .
> can anyone help me for this case.
> waiting for reply

Relevant Pages

  • Parallel Cable IV in Spartan 3E???
    ... Cable IV with flying leads instead of USB. ... Connecting to cable in ECP mode. ... interface to the target system (pin 2). ...
    (comp.arch.fpga)
  • Re: CE Target Control is disabled
    ... PB got into debug mode automatically, some debug output occurred and also the menu options within Target->* were enabled. ... beitman AT applieddata DOT net ... An ISO 9001:2000 Registered Company ... Microsoft WEP Gold-level Member ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Stream Device Driver How-to
    ... Do you have Ship build set in the project settings? ... beitman AT applieddata DOT net ... image and the registry on the target shows the correct entries. ... expected to see some debug messages from the driver on the debug output ...
    (microsoft.public.windowsce.platbuilder)
  • Re: WinCE boot up
    ... beitman AT applieddata DOT net ... Debug messages are output without intervention from the CE drivers. ... case of serial debug output, the messages are simply sent to the TXD ... The hardware which I have does not have the serial port, ...
    (microsoft.public.windowsce.platbuilder)
  • Re: wceusbsh serial port?
    ... that ActiveSync be shut down on the PC prior to connecting. ... beitman AT applieddata DOT net ... Microsoft WEP Gold-level Member ...
    (microsoft.public.windowsce.embedded.vc)