Re: Intel PXA27x WinCE 5.0 eboot.bin no serial output

From: Leif O (leif_nospam_at_vmetro.no)
Date: 11/29/04 

Date: Mon, 29 Nov 2004 14:16:48 +0100

Verify that eboot uses the correct PXA27x UART. Maybe it is set up to use
e.g. the BTUART as a default instead of e.g. the FFUART (which is probably
the UART you want to use)

Regards,
Leif O

On 29 Nov 2004 01:01:35 -0800, Tang <ymtang@gmail.com> wrote:

> Hi, I am working on Intel PXA27x, OS wince 5.0. I built eboot.bin and
> used Jflashmm to flash in eboot.nb0. After power on the board, the LED
> displayed as 3..2..1..0, but hyper terminal didn't show any debug
> print. I believe bootloader is still running because if I wait for a
> while I can still download the image using PC ethernet download. How
> can I enable the debug print in the eboot? The hyper terminal setting
> is 38400, no hardware flow control, no parity, 8 bit, 1 stop bit.
>
> Same board works fine for WinCE4.2.
>
> Thanks a lot
>
> Tang 

-- 
Using M2, Opera's revolutionary e-mail client: http://www.opera.com/m2/