"Port not available" is shown with ActiveSync after cold boot
Date: Mon, 29 Nov 2004 18:31:39 +0800
Hi,
After I cold-boot our device if there is a USB connection between our device
and PC, "Port not available" is shown sometimes.
As a result, activeSync is not connected.
It seems to be caused owing to fail to setup the activeSync connection.
Is it because USB driver is loaded too earlier ?
How to solve this issue ?
Thanks.
Yu.
Relevant Pages
- Re: AciveSync serial connection problems
... It turns out that the COM port hardware on my CE device was inverting the ... I checked that ActiveSync was working in 5.0 with a CEPC. ... COM4 is not the debug com port, ... I configured ActiveSync to use my connectoid via the PC Connection ...
(microsoft.public.windowsce.platbuilder) - Re: cant connect to internet
... Not knowing how you have your computer setup it is hard to say. ... preventing accesibilty to your internet connection on your computer. ... Activesync requires that the following ports need to be available: ... then Activesync sits there listening on port ...
(microsoft.public.pocketpc) - Re: Bluetooth sync with ActiveSync FRESHLY installed
... You mean to get by the initial connect your device wizard? ... persistent you can get by that and have AS up with no initial connection. ... >> what comm port is an available BT port. ... It will be an ActiveSync one. ...
(microsoft.public.pocketpc) - Re: active sync cant connect when in cradle (cable works fine)
... For some reason it is trying to initiate a connection via the COM port. ... disabling the COM port setting under ActiveSync on your desktop (File -> ... Since the cradle works fine on another computer, ...
(microsoft.public.pocketpc.activesync) - Re: ActiveSync, Get a handle over the device object
... unchecking the USB connection in ActiveSync or killing the wcescomm.exe ... > to obtain a handle to the device object. ...
(microsoft.public.pocketpc.activesync) |
|
