Re: Intel PXA27x WinCE 5.0 eboot.bin no serial output
From: mobilevil (kccheng_at_kachun-youknowwhat.com)
Date: 11/29/04
- Next message: Yu: ""Port not available" is shown with ActiveSync after cold boot"
- Previous message: Tang: "Intel PXA27x WinCE 5.0 eboot.bin no serial output"
- In reply to: Tang: "Intel PXA27x WinCE 5.0 eboot.bin no serial output"
- Next in thread: Leif O: "Re: Intel PXA27x WinCE 5.0 eboot.bin no serial output"
- Messages sorted by: [ date ] [ thread ]
Date: Mon, 29 Nov 2004 18:09:42 +0800
5.0 is using the com port on the left side of the board LOL
"Tang" <ymtang@gmail.com> wrote in message
news:8812976b.0411290101.724df4a3@posting.google.com...
> Hi, I am working on Intel PXA27x, OS wince 5.0. I built eboot.bin and
> used Jflashmm to flash in eboot.nb0. After power on the board, the LED
> displayed as 3..2..1..0, but hyper terminal didn't show any debug
> print. I believe bootloader is still running because if I wait for a
> while I can still download the image using PC ethernet download. How
> can I enable the debug print in the eboot? The hyper terminal setting
> is 38400, no hardware flow control, no parity, 8 bit, 1 stop bit.
>
> Same board works fine for WinCE4.2.
>
> Thanks a lot
>
> Tang
- Next message: Yu: ""Port not available" is shown with ActiveSync after cold boot"
- Previous message: Tang: "Intel PXA27x WinCE 5.0 eboot.bin no serial output"
- In reply to: Tang: "Intel PXA27x WinCE 5.0 eboot.bin no serial output"
- Next in thread: Leif O: "Re: Intel PXA27x WinCE 5.0 eboot.bin no serial output"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
|
