Re: unable to boot cepc from HD
From: Sujith (sujithss_at_hotmail.com)
Date: 10/29/04
- Next message: Ajay: "USB Function Driver ERROR !"
- Previous message: Sujith: "Re: regarding boot.bib and config.bib"
- In reply to: Radha Kumar Reddy: "unable to boot cepc from HD"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 29 Oct 2004 10:37:01 +0530
post the error message may be some one can help.
Regards
Sujith
"Radha Kumar Reddy" <RadhaKumarReddy@discussions.microsoft.com> wrote in
message news:7E1F3B24-08AD-4C79-8D62-16ABF2D54F73@microsoft.com...
> Thanks Sujith,
> I tried to boot winCE from hard disk. I did what exactly was told in the
> tutorial ->
> created to disks ( setup and boot ) ,
> formatted the HD,
> setup the environment,
> copied the files from bootdisk to HD,
> copied the nk.bin by connecting this HD to another system as slave.
> And made change in autoexec.bat to loadcepc nk.bin. ( I didnot give any
cmd
> line options )
> But when I boot the cepc, it gives the splash screen and jumps to blue
> screen with some error number.
>
> I do not understand why it doesnot boot. I am left with no clues. any help
> in this regard is of great appreciation.
>
> thnx.
> Radha Kumar Reddy.
>
> "Sujith" wrote:
>
> > Hi,
> > so basically it is downloading..
> > good. may be you can trap the debug messages using the other COM port
and
> > check-out what went wrong.
> > possible options could be.. the display driver should be the same as the
> > target machine.. not host machine..
> > more over are you able to get the machine id in the configure remote
> > connection, ethernet.settings..?
> > if yes.. ok. if no.. add the correct driver for the device(ethernet). it
> > should work at any cost..
> > regards
> > Sujith
> > "Radha Kumar Reddy" <Radha Kumar Reddy@discussions.microsoft.com> wrote
in
> > message news:A21B40CB-2DBA-45CA-9242-0421485DBE81@microsoft.com...
> > > h/w platform: a p4 desktop
> > > winCE platform used : 5.0 CEPC
> > > eboot : when I boot from floppy and select eboot option, it tries to
> > access
> > > the host machine but in vain, displays an error msg saying "jumping to
> > > 0x...." some hex code.
> > > sboot : I connected the target PC to host using serial cable, used
sboot
> > > option to download. the target displays msg "jumping to 0x...." some
hex
> > code
> > > other than the above. BUT the host **starts** download process to
target.
> > > takes a lot of time. but at the end nothing happens at target even
after
> > > download completes.
> > >
> > > I am new to WinCE. unable to understand whats happening. please help
me
> > out.
> > > Thanks.
> > > Radha Kumar Reddy.
> >
> >
> >
- Next message: Ajay: "USB Function Driver ERROR !"
- Previous message: Sujith: "Re: regarding boot.bib and config.bib"
- In reply to: Radha Kumar Reddy: "unable to boot cepc from HD"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
