Touching immediatly after WinCE boot blocks calibration (Touch Pan

From: Robin (Robin_at_discussions.microsoft.com)
Date: 09/30/04 

Date: Thu, 30 Sep 2004 01:55:08 -0700

We use the touch panel (display) driver included with Platform Builder 4.2.
We have did some modification related our touch panel controller (Serial DMC
controller, FIT-10IF).
Basically is works, but I encountered one issue:

- When touching the display immediatly after WinCE has booted, the touch
panel reacts, the calibration data is incorrect. Touching the display blocks
the calibration load process. Stop touching for 1 a 2s and the touch panel
calibration data is loaded correctly. The touch panel works fine after this
calibration process.

Is this a common issue of the default touchscreen driver?
Is there a way to solve this?

Thank in advance,
Best regards,
Robin

Relevant Pages

  • Re: Touch sleeps
    ... And sometime it might because the Vref of the AC '97 codec is discharged (I ... assume you are using a codec with Touch panel controller) for some reason, ... backlight control doesn't know about it so the backlight is still on. ...
    (microsoft.public.windowsce.platbuilder)
  • Can not Resume to S0 from suspend in wince 6.0
    ... the system back to user idle. ... The display is dark before I touch the ... touch panel. ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Touch screen calibration
    ... The first question is - can you calibrate your touch panel through the control panel -> Display. ...
    (microsoft.public.windowsce.embedded)