PCI Multi-Serial Card

From: Dongquan.Z (dongquan_at_public.bta.net.cn)
Date: 08/27/04 

Date: Fri, 27 Aug 2004 15:04:57 +0800

I want to develop a PCI Multi-Serial card, and I want to extend four serial
port from a PCI bus. After the CE OS booted, I don't want the Device Manager
make it as a PCI device, and I want Device Manager make it as 4 serial
ports.

What should I do?

thanks!

Relevant Pages

  • Re: Direct I/O to device on PCI card
    ... > I am writing a program for direct I/O access to a hard drive in DOS. ... > What are the right addresses for accessing the device on a PCI card? ... > to(due to difference in architecture of the PCI bus) .. ... the PCI cardat boot up, port io to said ports is ISA/PCI ...
    (comp.lang.asm.x86)
  • PANIC with linux-next-2.6.26-next-20080718
    ... ACPI: ... ACPI: PM-Timer IO Port: 0x408 ... ACPI: bus type pci registered ... # Device Drivers ...
    (Linux-Kernel)
  • [PATCH]PCI Express Port Bus Driver
    ... A PCI Express Port is a logical PCI-PCI Bridge structure. ... physical device to be handled by only a single driver. ... service drivers will compete for a single PCI-PCI Bridge device. ...
    (Linux-Kernel)
  • 2.6.25.3: serial problem (minicom)
    ... a serial console, which the other reads using the minicom program. ... Allocating PCI resources starting at 10000000 ... system 00:08: iomem range 0xe8000-0xfffff could not be reserved ... SB audio device quirk - increasing port range ...
    (Linux-Kernel)
  • Re: SATA ahci Bug in 2.6.19.x
    ... ACPI: PM-Timer IO Port: 0x808 ... ACPI: Local APIC address 0xfee00000 ... Calibrating delay using timer specific routine.. ... ACPI: bus type pci registered ...
    (Linux-Kernel)