Cannot ping under CEPC

From: Oscar Douglas (OscarDouglas_at_discussions.microsoft.com)
Date: 07/30/04 

Date: Fri, 30 Jul 2004 05:15:03 -0700

Dear Sir./Madam:

I've just build over a CEPC platform with PB4.2. It seemed that the automatic configuration UI was funtioning with my NIC and revelant driver (not the same kind of interface as the one to download platform image) . And when I used it to connect an AP, I can sniff the AP ack with the assocation successful status and the ICMP package with IPV4 mode. But after I set up a static IP address, I can only sniff the ICMP page with IPV6 package, and the IPV4 package is lost. So, when I pinged the AP, the AP cannot recognized the IPV6 package and cannot reply the ICMP package. So the result is obvious.

I used the same driver code to build ARM-fited driver under WEBPAD, it can successfully ping with the same AP using the same NIC.

So, I've been very confused that what problem happened under CEPC?

I'm looking forward to your reply anxiously.

Sincerely yours,

Oscar Douglas