Intel PSM on Assabet-like board
From: Hari (anonymous_at_discussions.microsoft.com)
Date: 04/28/04
- Next message: Emil Falcon: "debugging web server with lmemdebug"
- Previous message: Bruce Eitman \(eMVP\): "Re: Add a driver to Wince .net 4.2"
- Next in thread: Dean Ramsier: "Re: Intel PSM on Assabet-like board"
- Reply: Dean Ramsier: "Re: Intel PSM on Assabet-like board"
- Messages sorted by: [ date ] [ thread ]
Date: Wed, 28 Apr 2004 15:01:19 -0700
Hi all,
I am using a custom board based on SA1110, which is very similar to Assabet. The PB Document says that Intel PSM is supported for Assabet board. As my board is very same as far as flash interface is concerned, I want to make use of Intel PSM for my board, but I am unable to do it. I was told earlier that I have to buy PSM from Intel. I am not fully convinced, as I could not get reason for that. Can you please help me out in this?
If necessary, I can write the Flash MTD level driver for my flash chips (which is again 28F160). How should I proceed. Can I be able to make use of PSM? Can anyone point to me some source for any flash file system?
Regards,
Hari.
- Next message: Emil Falcon: "debugging web server with lmemdebug"
- Previous message: Bruce Eitman \(eMVP\): "Re: Add a driver to Wince .net 4.2"
- Next in thread: Dean Ramsier: "Re: Intel PSM on Assabet-like board"
- Reply: Dean Ramsier: "Re: Intel PSM on Assabet-like board"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
|