Re: display resolution
From: Gary Daniels [MS] (garydan_at_web.microsoft.com)
Date: 02/28/04
- Previous message: Paul G. Tobey [eMVP]: "Re: Urgent, COM port problem"
- In reply to: Ernie Li [MSFT]: "Re: display resolution"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 27 Feb 2004 17:30:35 -0800
If you're using the standard "linear frame buffer flat driver", then the /L
option for LoadCEPC will change your resolution.
If you're using a specific display driver for your hardware, then you'll
have to research how that driver sets the resolution. The registry is the
most common method for setting the resolution in that case, however there's
no set registry keys.
Gary Daniels
Windows CE GDI Test
This posting is provided "AS IS" with no warranties, and confers no rights.
You assume all risk for your use. © 2002 Microsoft Corporation. All rights
reserved.
"Ernie Li [MSFT]" <ernieli@online.microsoft.com> wrote in message
news:%23X5uUkW$DHA.3536@tk2msftngp13.phx.gbl...
> You should be able to change your resolution when you boot from the
display
> of the CEPC. You could not change the resolution after boot up.
> Ernie
>
> "Carlo" <c.allegretti@multimodo.it> wrote in message
> news:OxL$vTU$DHA.3852@TK2MSFTNGP10.phx.gbl...
> > I made a CE 4.2 image for a VIA platform starting from standard CEPCx86.
> > When I run the image on the target I have 640x480 resolution.
> > If I go in the display properties window I don't have any change
> resolution
> > control panel.
> >
> > How can I change the resolution to 800 or 1024 ?
> >
> > Carlo
> >
> >
> >
>
>
- Previous message: Paul G. Tobey [eMVP]: "Re: Urgent, COM port problem"
- In reply to: Ernie Li [MSFT]: "Re: display resolution"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
|
