Re: Problems on ActiveSync on CE4.2 using UART

From: David Liao \(MS\) (davli_at_online.microsoft.com)
Date: 02/27/04 

Date: Thu, 26 Feb 2004 17:27:43 -0800

I believe ActiveSync only needs DSR and DTR handshaking which standard
BTUART does not have. Are you using GPIO pin to simulate those signal?

David Liao.

"Valter Minute" <vminute@REMOVEMEinwind.it> wrote in message
news:Xns949B80ADCCB0AVALTERMINUTE@207.46.248.16...
> "LL" <lilian@nospam.bokia.net> wrote in
> news:e4Zjc2D$DHA.268@TK2MSFTNGP10.phx.gbl:
>
> > Hi,
> >
> > I have problems implementing ActiceSync on WinCE 4.2. I am
> > implementing on PXA263. I am implementing ActiveSync on serial
> > connection via BTUART. On the PC side, I am using ActiveSync 3.7.1
> >
>
> ActiveSync needs a full UART and the BTUART on PXA (PXA255, at least)
> does not implement all RS232 control signals. ActiveSync works on the
> FFUART of PXA255.
>
>
> --
> Valter Minute
> vminute@inwind.it (the reply address of this message is invalid)

Relevant Pages

  • Re: Problems on ActiveSync on CE4.2 using UART
    ... I was able to get ActiveSync up finally. ... And it works with BTUART on PXA263, with connection RX,TX,CTS and RTS. ... how to synchronize better? ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Question on OpenNetCF Serial Port Demo
    ... No ActiveSync indicates that you don't have a fully-connected serial cable. ... there are some signals that don't get wired from one end to the other. ... > of my development machine directly to a COM port in the WinCE machine ...
    (microsoft.public.dotnet.framework.compactframework)
  • Re: Problems on ActiveSync on CE4.2 using UART
    ... > I have problems implementing ActiceSync on WinCE 4.2. ... > connection via BTUART. ... I am using ActiveSync 3.7.1 ... ActiveSync needs a full UART and the BTUART on PXA ...
    (microsoft.public.windowsce.platbuilder)