Re: Remote registry editor

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

While I would continue to work on connecting the remote tools becuase there
is a lot of value in knowing how to use them, last night I posted a Windows
CE registry editor to my blog that you can use if you have the .NET
CompactFramework installed on the device.

http://geekswithblogs.net/BruceEitman/archive/2009/07/27/window-ce-simple-little-registry-editor.aspx

--
Bruce Eitman (eMVP)
Senior Engineer
Bruce.Eitman AT EuroTech DOT com
My BLOG http://geekswithblogs.net/bruceeitman

EuroTech Inc.
www.EuroTech.com

"Mr Garbage" <MrGarbage@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:A7766BF5-8833-47DA-ACF4-7A0E45B5200A@xxxxxxxxxxxxxxxx
I am running Visual Studio 2005/Wince 6.0.
I have an x86 BSP that successfully boots CE on my target system.

On my target system I have 2 serial ports and a working Ethernet
connection with a static IP address.

I am (finally!) able to debug a test app from Visual Studio 2008 using
my ethernet connection and conmanclient2 and cmaccept.

I need the ability to look at the registry on my target system
and this seems like it would require Remote tools capability
from my VS 2005 system BSP system.

So far I cannot get this to work.

I have ActiveSync 4.5 installed but I don't think this works
over Ethernet.



Since I am able to debug using the ethernet connection
I would think that this is sufficient for getting the Remote Registry
Editor
up and connected. Perhaps not. There seems to be a lot of conflicting
info out there...

Do I need Kitl?
Do I need to use a serial port?


Thanks!

Mark




.

Relevant Pages

  • Re: Remote registry editor
    ... VS2005 and run the Remote Registry Editor externally to VS2005). ... KITL connection to talk to the device. ... I have an x86 BSP that successfully boots CE on my target system. ... my ethernet connection and conmanclient2 and cmaccept. ...
    (microsoft.public.windowsce.embedded)
  • Re: Problem with remote tools connection
    ... The connection with the non platform builder application can use the same ethernet connection? ... In my experience, running both the debug version of an image and the "Application Remote Tools" based on TCP yields some strange behaviors, mostly unexpected slownesses of the Remote Tools. ... If you don't have to debug low-level layers, I recommend that you use a Retail version of your image and that you perform pure application debugging with the "Application Remote Tools". ...
    (microsoft.public.windowsce.platbuilder)
  • Re: Remote Tools not connecting
    ... Can you check if platform manager is configured to use CESH + KITL ... > - Enable CE Target Control Support ... > it yields the same result (remote tools not working, ... >>> remote connection as Ethernet for both Download and Kernel Transport, ...
    (microsoft.public.windowsce.platbuilder)
  • Re: XP will not boot with DSL Modem Connected?
    ... If USB you may want to switch to a Ethernet connection to a ... a Broadband connection especially if you have higher speed. ... Now the only way I can get my system to bootup is to disable my modem. ...
    (microsoft.public.windowsxp.general)
  • Re: Remote Tools related problem with ActiveSync
    ... for accessing a device through the remote tools you need to have ... you are developing your own BSP, then you can easiy generate the SDK ... One problem related to ActiveSync occurs. ... The ActiveSync connection ...
    (microsoft.public.windowsce.embedded)