I have written an application (as a service) which lists down all the usb
devices conected. The problem I'm facing is that, when i boot the machine
with some usb devices connected, my application does not list them(Device.exe
runs before service.exe).. How do I programatically re-enumerate ALL the usb
devices that are already up and running? (My intention is to use
DisableDevice exposed by USBD. But where do I get the device handle?)
PS : Here there is an added issue. There could be some "unknown" devices
(usb devices without drivers) alread connected! How can I re-enumerate these
devices?
Re: fedora-list Digest, Vol 46, Issue 122 ... Re: list subject (Tim)... It's far quicker to switch over to the Fedora... I read messages from the public lists.... If you boot with your USB drives connected,... (Fedora)
Re: Mount issue ... The error is about the mount point. ... The second column lists the position (mount ... illegal rule for the USB hard disk.... newer) has this power conservation feature that limits the power output ... (Ubuntu)
Re: SimpleTech USB HDD driver ... I was under the impression though that USB HDDs... No worries - it's what the lists are for. ... AFAIK all USB mass storage devices should be supported by the umass driver,... I use various flash cards and 'pen drives'... (freebsd-hackers)
Re: [SLE] usbdevfs needed for Microtek scanner install/setup??? ... > reply without crossposting to various lists.... >> Trying to set up an old Microtek Scanmaker X12USL without much ... > the sane-microtek2 man page there is only SCSI mentioned.... This scanner has ports for both SCSI and USB.... (SuSE)
Re: USB regression (and other failures) in 2.6.2[45]* ... the folders I have set up for various mailing lists,... attempt to detect the network card by modprobing every network ... then none of your USB devices would be able to run at high speed. ... (Linux-Kernel)
