Re: print spooler service not running

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

well I am just simple minded and start reading the firtst post and than the
2th and so on. in this way it is always clear to me and most of the people I
know act in that same way, it is also commonly used here.

This style of messaging botom to top mail can give the impression a question
is not answered.

that is why I asked.

Best regards,
Michel Denie


"antioch" <antioch@xxxxxxxx> wrote in message
news:OuGFwETIHHA.2632@xxxxxxxxxxxxxxxxxxxxxxx
Reply contextualised/clipped/intertwined

"realcestmoi" <mdenie@xxxxxxxxxxx> wrote in message
news:OIpVm0KIHHA.1276@xxxxxxxxxxxxxxxxxxxxxxx
Hi there, Why is everyone typing answers at the bottom I wonder?

Bottom posting - in general it can make it easier to follow a thread. Its
a personal issue.
I have clipped your post of other posts still attached, but have no
revelance to your question.

I think it takes a lot of scrolling after 40 replies to see what is new;)
Yes it can if posters do not contextualise and clip properly.
There are very good reasons for using the recommended newsgroup quoting
style. It has to do with making it easy for others to understand what you
are talking about when you post a reply to anything by placing your
comments into context.
1) If you do not quote at all in a reply you leave the reader guessing at
what you are replying to.
2) If you quote the entire message but then post your reply above or below
the the message you are responding to, and the message happens to be very
long and cover a lot of topics of discussion, again you leave the reader
guessing as to what part of the message your reply was for.
This is why you should put your replies into context.
4) Newsgroup quoting styles have been in use now for well over 20 years,
they are very well understood and accepted quoting practices among those
who participate in newsgroup threaded discussions. Because of that, if you
choose for whatever reason to not follow these accepted practices, then
you invite criticism. Quite often people who fail to follow accepted
practices
in threaded discussions and choose to ignore request to start doing so,
will eventually be ignored completely and/or not taken seriously.
5) It's bad form to quote the entire message of an OP (Original Poster)
especially so if that message is more than just a few lines in length,
unless you are doing a point by point response to the message and properly
contextualizing your responses as you go. You should [snip] any comments
you
are not responding to.
6) Address the person to whom you are replying and sign off at the end of
your post.
Here are some guidelines about how to correspond in newsgroups
http://members.fortunecity.com/nnqweb/nquote.html

Best regards,

Michel Denie

Rgds
Antioch





.

Relevant Pages

  • Re: print spooler service not running
    ... the the message you are responding to, and the message happens to be very ... This is why you should put your replies into context. ... Newsgroup quoting styles have been in use now for well over 20 years, ... Quite often people who fail to follow accepted practices ...
    (microsoft.public.windowsupdate)
  • Re: OT: Wuzzy - Captain Carnivore
    ... the context ... informed by the post to which you are responding. ... the meaning of your posts in a vacuum without any context to what came ... If you're asking what fun it is to hunt in a way that makes it a challenge ...
    (rec.gambling.poker)
  • Re: Need help with an odd method
    ... Responding to Krug... ... on the problem context. ... In that case separate interface methods may be quite ... upon the sender context while the method is designed around intrinsic ...
    (comp.object)
  • Re: Evolution DISPROVEN by SIN!!!
    ... >> Sure is but you don't indicate any context. ... > them my game and they've made the intelligent choice to stop responding. ... feed the troll' but if you know you're a troll, ...
    (talk.origins)
  • Re: ***NEED HELP PLEASE***
    ... If you quote the entire message but then post your reply above or below ... the message you are responding to, and the message happens to be very long ... Newsgroup quoting styles have been in use now for well over 20 years, ... Quite often people who fail to follow accepted practices ...
    (microsoft.public.security.virus)