Re: terminal server printing issues with redirecting

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

Thanks for your post Rob. I have checked all of these problems you
suggested below. I also did an uninstall and reinstall taking the
application mode and user rights for NT4.0 users. I still do not get any
ports with tsc001. Do you have any other suggestions?

Thanks for your help!

Matt


"Rob Leitman [MS]" <robleit@xxxxxxxxxxxxxxxxxxxx> wrote in message
news:elZDyfzGHHA.4804@xxxxxxxxxxxxxxxxxxxxxxx
Here are some things to check:

1. Check the event log for any events from TS printing
2. Check if rdpdr device driver is installed and running
3. Check if the spooler is enabled and running
4. Check tscc configuration to see if printer mapping is enabled
5. Check that the TS client setting has Printer redirection enabled
6. Check if the drivers for the client printer are available on the win2k
server

Rob

"Matt Cortner" <mcortner@xxxxxxxxx> wrote in message
news:eVctaeoEHHA.3188@xxxxxxxxxxxxxxxxxxxxxxx
I have a windows 2000 terminal server that I had to uninstall and
reinstall terminal server and terminal server licensing for reasons I will
not get into. After doing this everyone who had had trouble logging on
can now log on but they cannot print. It use to add a ' TSC### ' port
when they logged on with the client's local printer attached to that port.
Then they could print to that terminal server port. It does not add those
ports anymore and therefore the clients cannot print. I do not know if
"enable bidirectional support" needs to be checked but I cannot check it
on any printers installed, local or otherwise, as it is greyed out on all
printers.

Any assistance on this would be much appreciated. I have looked through
these posts and online for several hours now and I cannot come up with
anything.

Regards,

Matt




.

Relevant Pages

  • Re: What is the best GPS Plotter to buy
    ... Meindert on the net is the manufacturer of a nice NMEA multiplexer. ... manufacturer stuff to connect just to one port. ... Just feed each device into a terminal server port and go from ... is a terminal server using tcp/ip a serial connection to the source of the NMEA output that connects to more RS232 ports, that is...is it a piece of hardware that is a serial port connecting cable that "branches" into a module having any number of additional serial ports, and whose original single input signal is then available for "processing" on each of the module's additional connecting devices? ...
    (rec.boats.cruising)
  • Re: thin client com ports
    ... I'm glad that you got at least one more client working! ... MCSE, CCEA, Microsoft MVP - Terminal Server ... the COM port settings? ... I am testing several thin clients. ...
    (microsoft.public.windows.terminal_services)
  • Re: Shared User Folders and printer setup
    ... So something with the printer port your creating doesn't actually pay attention to properly mapped drives. ... Microsoft MVP - Terminal Server ... In order to get this software to work Trans-Micro (the makers of Check Factory) have a detailed procedure that allows multiple Terminal Server users to run the software at the same time. ... Does anyone have any idea why and how can I get it to look at the Home directory path Z: ...
    (microsoft.public.windows.terminal_services)
  • RE: Externe toegang SBS
    ... The system controls the port creation and deletion automatically. ... to let the printer redirection work in the Windows 2003 terminal server, ... You must enable the printer redirection on the RDP client. ... Windows Printer Mapping ...
    (microsoft.public.windows.server.sbs)
  • Re: Sun E450 Serial Console Problems...
    ... is setting the port to 7-e-1. ... I needed to set imask_7bits to Y on the terminal server. ... It said that there should be no port monitor service running on the serial ... It comes through with characters with umlaudaes and other ...
    (SunManagers)