Cannot Access Internet after connecting to VPN on Windows Server 2003

Tech-Archive recommends: Fix windows errors by optimizing your registry

Hello,

I am stuck with a problem in setting up VPN on my machine. I have a
Windows 2003 server that is connected to a Netgear MR814 router which
goes out to a DSL connection. I have DHCP enabled on the connection.


I use Secu Remote to connected with two VPNs (which secu Remote
allows). Further, because of some problems at one VPN end, I have set
my router to pick up from a pool different than the default pool of IP
Addresses (I could not link to one of the VPNs till I did that).


Now my problem is that, while I link successfully to both networks
simultaneously, the moment I get SecuRemote running my access to
internet goes.


All searches tell me that I should disable the 'use default gateway'
option. But I am yet to locate that option on the Windows 2003 server.


I would be glad if someone could give me pointers in this direction.


Thanks
Ritu

.

Relevant Pages

  • Re: VPN - desparate housewife part 2
    ... Further to your reply and further study of the Router guide states a VPN ... All traffic is then directed to Server. ... > connection from a LAN client to your VPN server using its LAN IP. ...
    (microsoft.public.win2000.ras_routing)
  • RE: VPN connection not passing the password auth stage.
    ... I understand that when you try to establish a VPN ... connection, the connection fails in the process of verifying the ... PPTP client and a PPTP server. ... The router must be able to pass Generic ...
    (microsoft.public.windows.server.sbs)
  • RE: VPN issue on SBS2003
    ... I understand that you encountered VPN connection issue when you use VPN to ... Internet clients or VPN to external VPN Server from SBS Client computers? ... Configure E-mail and Internet Connection Wizard ... Total GRE packets sent = 1 ...
    (microsoft.public.windows.server.sbs)
  • Re: static routing
    ... Connections work going out from inside the router, ... I'll have to remove the router and connect the server directly to the cable ... A static route has been added that matches the subnet ...
    (microsoft.public.windows.server.networking)
  • Re: VPN Error 778
    ... Then run the Remote Access Wizard for VPN setup. ... Then try to VPN from a port on the router. ... I'm running EZtrust antivirus on the server, ... using a wireless connection, one a desktop using an ethernet ...
    (microsoft.public.windows.server.sbs)