I have 2 scsi drives, scsi-id-0 and scsi-id-1. id-0 failed.
I can not get server to boot from id-1.
I set id-1 to id-o, nothing after the bios screen, just a black screen
from
bios and no failures.
It is as if the drive is not active or the boot.ini file is not being
read.
All three volumes are on the drive.
Need some ideas quickly!
ps- when booting from cd1 of sbs2003, it does not see C:\.
Re: Boot problem/failure small business server 2003 SP 2 ...Windows 2003 installation. ... How to troubleshoot startup problems in Windows Server 2003 ... And when done so after F8, cannot boot in any ...Drectory Services Repair Mode:: runs, shows, Windows starting ... (microsoft.public.windows.server.sbs)
Re: Dual Boot Problem-Revisited ... The boot.ini at C:\ is responsible for the second boot screen because I ... may consider re-setting the boot file with the Windows Recovery... then installed Server 2003 on the second drive...". ... My question why the two screens, why aren't the choices just Windows ... (microsoft.public.windowsxp.general)
Re: Dual Boot Problem-Revisited ... The boot.ini at C:\ is responsible for the second boot screen because I ... may consider re-setting the boot file with the Windows Recovery... then installed Server 2003 on the second drive...". ... My question why the two screens, why aren't the choices just Windows ... (microsoft.public.windowsxp.general)
Re: Dual Boot Problem-Revisited ...Windows XP loaded properly but Server 03 would not boot.... Rather than fooling around, I decided to re-install Server... two separate screens as seen below: ... (microsoft.public.windowsxp.general)
