Re: Monitoring and Reporting not working

Yes that is correct. That is the exact error message on both monitoring and
reporting and backup.
I am currently working on the following steps suggested by Terrence Liu

Ron

"Dan Walker" <danw@xxxxxxxxxxxxxxxxx> wrote in message news:%23UXq6mvaHHA.2436@xxxxxxxxxxxxxxxxxxxxxxx
Ron,

When you try to use the Monitoring and Reporting snap-in or the Backup snap-in do you receive the following error message:

The page cannot be found.
HTTP 400 - Bad Request

Dan
"Ron Brown" <rbrown_nospam@xxxxxxxxxxxxxx> wrote in message news:6B255BCE-C64A-4B93-AEAC-4AB4BE5846E1@xxxxxxxxxxxxxxxx
Premium

"Dan Walker" <danw@xxxxxxxxxxxxxxxxx> wrote in message news:%23wFQZOpaHHA.1508@xxxxxxxxxxxxxxxxxxxxxxx
Ron,

Are you running SBS Standard or Premium?
"Ron Brown" <rbrown_nospam@xxxxxxxxxxxxxx> wrote in message news:4FDFC228-D359-4913-86A9-51A3023B17C5@xxxxxxxxxxxxxxxx
Hi Dan,

Negative. Nothing at all in the event viewer. I just did a restart on the server and everything loaded
and I checked to make sure that the SQLServerAgentMonitoring started and it started with no errors.
I also checked to see if any other tabs on the server management was not working and found that the
backup tabs is in the same state as monitoring and reporting. I have nothing to go on that would explain
what is happening.

Ron

"Dan Walker" <danw@xxxxxxxxxxxxxxxxx> wrote in message news:eJwEh1oaHHA.4940@xxxxxxxxxxxxxxxxxxxxxxx
Any errors in the Event Viewer?

Dan
"Ron Brown" <rbrown_nospam@xxxxxxxxxxxxxx> wrote in message news:D7195C8B-0FBA-4E18-9E85-93A404BE1BDA@xxxxxxxxxxxxxxxx
Hi Group,

I just installed a fresh SBS2003 (Pre) Everything went fine with no errors.
I have gone through all the steps afterwards to configure the server and even
installed SP2. Prior to installing SP2, the monitoring and reporting feature was
working, but afterwards it stopped. So I ran the configure wizard and that did
not work. Tried uninstalling and reinstalling via the add/remove programs for
SBS and that did not work. Uninstalled SP2 and ran the configurations again
and it is still not working. Is this a known issue or have I misconfigured something?
Can someone please advise me on how to resolve this issue.

Thanks,
Ron









.

Relevant Pages