DNS resolution

Hi all, I have the following problem:

I have setup an SBS server, and I am attempting to connect a client pc
to it. DHCP is setup, and the sever assigns the client an IP address
from the list.

Under ipconfig /all on the client the DHCP server shows up as
192.168.1.200 (correct), but when i type in nslookup it comes up with
server name unknown & address 127.0.0.1. & i can't figure out why.

On the server i have two network cards, external (for the internet)
setup as:

192.168.1.2
255.255.255.0
192.168.1.1

DNS 192.168.1.200

Internal card (for the LAN)

192.168.1.200
255.255.255.0
No gateway

DNS 192.168.1.200

The nslookup command reports the correct server name & address.


Has anyone got any ideas as to how i can resolve this issue, as it has
been giving me a real headache for the last few days.

Thanks in advance.

.

Relevant Pages

  • Re: Application Hang
    ... Back to DHCP, what about the client ipconfig without the DG ip address? ... When the old server crashed, it required a new motherboard and CPU. ... You should see at least,006 DNS servers, 003 Router. ...
    (microsoft.public.windows.server.networking)
  • Re: Windows Server 2003 DHCP server - Does not release IP Addresses
    ... on the SWITCH or the ROUTER. ... the clients will not know which server to go for DHCP REQUEST. ... And, if that Switch had some issues, how will the other DHCP server ... This error is usually received when the client booting up via PXE is ...
    (microsoft.public.windows.server.general)
  • Re: DHCP handles Naks one one vlan differently
    ... If the problem is on the network with the DHCP server, ... Frame 156 ... Your (client) IP address: 0.0.0.0 ...
    (comp.dcom.sys.cisco)
  • Re: Sending hostname with DHCP
    ... default route and the default dns host. ... Below is my /etc/resolv.conf created by the dhcp client. ... > This seems to depend on the client as much as the server. ...
    (Fedora)
  • Re: DHCP server not responding to clients on other subnets
    ... When I do my tests I shutdown the other DHCP server (or I disconnect it from ... client workstation I get the message "DHCP server unreachable". ... Hardware type: Ethernet ...
    (microsoft.public.windows.server.networking)