Re: RAID1 implementation
- From: "mike" <mike@xxxxxxxxxx>
- Date: Mon, 5 Dec 2005 23:30:56 -0000
If you are talking SOFTWARE RAID - forget it
Don't use it at all.
If you are talking IDE or SATA RAID - don't use it unless its a Small Server
at home!!
SCSI and Hardware RAID is the only way to go.
RAID - can be setup AFTER installation
I usually do it when everything else is working ok.
I would then disconnect one drive and put it away
get new drive and do it again
Its also worth doing this before applying patches
saves a lot of grief
"Tom Mc" <TomMc@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:77CCB218-30A3-4572-8E9D-BCEB1071EE41@xxxxxxxxxxxxxxxx
> Does disk mirroring need to be set up during the installation of SBS 2003
> standard or can it be implemented after deployment? The hardware is all in
> place for it but it was not done during the installation. If done now,
after
> deployment of clients and user accounts, will there be any gotchas or
special
> preparation that needs to be done?
>
> Thx
> --
> Tom
.
- Prev by Date: Re: mac entourage and sbs
- Next by Date: Re: GPO problems
- Previous by thread: Re: RAID1 implementation
- Next by thread: Re: SBS/Exchange Antivirus
- Index(es):
Relevant Pages
|
