Re: Receiving NDR when trying to use Smarthost

I am not familiar with that particular layout, on my server I am loooking at
Advanced Management>Exchange>Servers>Servername>protocols>SMTP>default SMTP
Virtual Server, right click the server, left click properties, Delviry tab,
Advanced button, just above Smarthost is FQDN, if it has the .local it may
not send out mail correctly.

"Phil" <Phil@xxxxxxxx> wrote in message
news:OSTfyt7WFHA.2288@xxxxxxxxxxxxxxxxxxxxxxx
> On the "General" tab of the properties for the Smarthost Connector I
> created, in the box that says "Forward all mail through this connector to
> the following smarthost:" that is where I put the (smtp.sbcglobal.net)
> FQDN. That is above the local bridgeheads box that I have the servername
> in. I'm assuming that's what you're looking for. Thanks for your help so
> far.
>
> Phil
>
> <wedor> wrote in message news:%23Zhn4G0WFHA.3464@xxxxxxxxxxxxxxxxxxxxxxx
>> And....the AOL addresses is where you are having problems so....lets look
>> there.
>>
>> Just above the box on the connector where you put in the server to use as
>> a smarthost is a box for a FQDN, what do you have listed in that box?
>>
>>
>> "Phil" <Phil@xxxxxxxx> wrote in message
>> news:%23SyPNNxWFHA.3676@xxxxxxxxxxxxxxxxxxxxxxx
>>>I should've clarified in my last post - The Smarthost connector is only
>>>being used for AOL.com addresses. All other emails are sent via DNS.
>>>
>>>
>>> "Phil" <Phil@xxxxxxxx> wrote in message
>>> news:eR84HKxWFHA.3716@xxxxxxxxxxxxxxxxxxxxxxx
>>>> Hmmmm, here is where my ignorance of Exchange is going to show. Are
>>>> you referring to something in the properties of the Default SMTP
>>>> connector? If so, why would that matter? I created a new connector and
>>>> named it "Smarthost Connector" or something like that. I just need you
>>>> to be a little more specific.
>>>>
>>>> Thanks
>>>> Phil
>>>>
>>>> <wedor> wrote in message
>>>> news:%23o69WLmWFHA.2976@xxxxxxxxxxxxxxxxxxxxxxx
>>>>> What do you have listed as the FQDN (the box just above the SmartHost
>>>>> listing) in the SMTP connector?
>>>>>
>>>>> "Phil" <Phil@xxxxxxxx> wrote in message
>>>>> news:OmgGhilWFHA.2692@xxxxxxxxxxxxxxxxxxxxxxx
>>>>>> Alrighty then, there goes my initial hunch out the window. Any
>>>>>> suggestions as to why we would be getting this error on the NDR?
>>>>>>
>>>>>> Phil
>>>>>>
>>>>>> <wedor> wrote in message
>>>>>> news:eFeL3SlWFHA.3140@xxxxxxxxxxxxxxxxxxxxxxx
>>>>>>> That server does not normally require authentication at least not
>>>>>>> where I am using it, the yahoo based one requires authentication.
>>>>>>>
>>>>>>> "Phil" <Phil@xxxxxxxx> wrote in message
>>>>>>> news:umlxoOkWFHA.3320@xxxxxxxxxxxxxxxxxxxxxxx
>>>>>>>> Running SBS 2k3 (Std.) connected via DSL (SBC). Customer was
>>>>>>>> having problems emailing AOL.com addresses so I setup a Smarthost
>>>>>>>> connector specifically for AOL addresses per the instructions on
>>>>>>>> here:
>>>>>>>> http://www.sbslinks.com/DNS_Smarthost.htm
>>>>>>>>
>>>>>>>> Now whenever they are emailing an AOL address they are getting an
>>>>>>>> NDR from Exchange - "550 5.7.1 Access Denied". I'm guessing it is
>>>>>>>> probably because the SMTP server (smtp.sbcglobal.net) they are
>>>>>>>> trying to relay to requires authentication but I haven't figured
>>>>>>>> out where to put the credentials. Any suggestions?
>>>>>>>>
>>>>>>>> Thanks,
>>>>>>>> Phil
>>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>
>>>>>>
>>>>>
>>>>>
>>>>
>>>>
>>>
>>>
>>
>>
>
>


.