Re: RRas wizard fails error %1!s!

From: Marina Roos [SBS-MVP] (marina_at_roos.nodontwantspam.nl.com)
Date: 12/16/04 

Date: Thu, 16 Dec 2004 02:59:48 +0100

Hi Mmouse,

Can you post the last few lines from the rras log? 

-- 
Regards,
Marina
Microsoft SBS-MVP
"MMouse99" <MMouse99@discussions.microsoft.com> schreef in bericht
news:C4973B89-3B63-4A2C-9053-76E019AB6431@microsoft.com...
> Hi All,
>
> By RRAS for dail-in has stoppped working. Rebooted the server early this
> morning and RRAS would not answer the ringing modem. So I went through the
> server manager wizard (I have had to do this b4!). This time the wizard
jumps
> from page 1 to the last page and I get the following error message;
>
> An error occured while running the Remote Access Wizard. For details,
%1!s!,
> and then rerun the Remote Access Wizard.
>
> I have tired to stop the RRAS service, but that states it is stopping.
>
> Your help is much needed

Relevant Pages

  • Re: rasman 20209 vpn unable to authenticate
    ... current firewall settings and confirmed that VPN was checked. ... I had previously started the RRAS aplet on the control panel and viewed ... So I reran the connect to internet wizard and the remote access wizard ... router your SBS WAN NIC is plugged in, give it a static IP in the same ...
    (microsoft.public.windows.server.sbs)
  • Re: Site to site vpn SBS RRAS
    ... Have you looked at RRAS to see how many VPN ports are set up??? ... Did you run the remote access wizard on each SBS server? ...
    (microsoft.public.windows.server.sbs)
  • Re: Cannot configure RRAS
    ... I did do the re-register steps ... ... Kevin Weilbacher ... I followed the suggestion to disable RRAS and rerun the Configure ... and then rerun the Configure Remote Access wizard. ...
    (microsoft.public.windows.server.sbs)
  • Re: Cannot configure RRAS
    ... from John Bay which sorted me out. ... I followed the suggestion to disable RRAS and rerun the Configure ... > Specifying error location returned OK ... and then rerun the Configure Remote Access wizard. ...
    (microsoft.public.windows.server.sbs)
  • RRas wizard fails error %1!s!
    ... By RRAS for dail-in has stoppped working. ... server manager wizard. ... from page 1 to the last page and I get the following error message; ... An error occured while running the Remote Access Wizard. ...
    (microsoft.public.windows.server.sbs)