Re: Cannot access network share
- From: Rob <robertscottbrown@xxxxxxxxx>
- Date: Tue, 27 May 2008 08:56:24 -0700 (PDT)
I noticed that as well. However, if I look at the properties of the
NIC under TCP/IP I have it set to enabled instead of auto. But, I
can't ping it. It will resolve but not reply. The firewall is turned
off. There aren't any NAT settings. As you can see, the WAN NIC uses
a public IP.
Thank you,
Robert Brown
On May 27, 8:15 am, "Robert L. \(MS-MVP\)" <findem...@xxxxxxxxxxxxxxx>
wrote:
The routing looks good to me. You should be able to ping it. If not, check.
any firewall or NAT settings. Also I don't see NetBIOS over TCP/IP enabled..
--
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting onhttp://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access onhttp://www.HowToNetworking.com"Rob" <robertscottbr...@xxxxxxxxx> wrote in message
- Follow-Ups:
- Re: Cannot access network share
- From: Robert L. \(MS-MVP\)
- Re: Cannot access network share
- References:
- Cannot access network share
- From: Rob
- Re: Cannot access network share
- From: Robert L. \(MS-MVP\)
- Re: Cannot access network share
- From: Rob
- Re: Cannot access network share
- From: Robert L. \(MS-MVP\)
- Re: Cannot access network share
- From: Rob
- Re: Cannot access network share
- From: Robert L. \(MS-MVP\)
- Cannot access network share
- Prev by Date: Re: VPN Client through router problem
- Next by Date: Re: Windows 2008 Networking
- Previous by thread: Re: Cannot access network share
- Next by thread: Re: Cannot access network share
- Index(es):
Relevant Pages
|