Re: Setting routing to link 2 sites by VPN

Hi Bill, but what is the two sites were on a different subnet?



"Bill Grant" <not.available@online> wrote in message news:Oe7eb%23CRIHA.3916@xxxxxxxxxxxxxxxxxxxxxxx
This should mainly happen automatically. The only traffic using the tunnel would be traffic addressed to the private IPs of machines at the "other" site. http traffic would only use it if the http server was actually located at this site. Traffic addressed to any other IP address will still go out to the Internet unencrypted. Only the private traffic for the "other" site will be tunnelled (ir encrypted and encapsulated).

"Fred Bloggs" <fredb@xxxxxxxxxxxx> wrote in message news:D466CF4E-6C4A-4297-9842-370E110253FC@xxxxxxxxxxxxxxxx
Alas the router in the initial stages is not able to support this,
so all the routing etc needs to be done via windows...until that is i get a 2nd line in with bigger and better cisco hardware


"Lanwench [MVP - Exchange]" <lanwench@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message news:OEjrsbBRIHA.1188@xxxxxxxxxxxxxxxxxxxxxxx
Fred Bloggs <fredb@xxxxxxxxxxxx> wrote:
I'm looking to join 2 sites via a vpn, however the vpm link will not
be used for www traffic at the 2nd location.
The 2nd office will have it's own dedicated www link to keep traffic
to a minimum on the VPN.
Both sites are on seperate subnets.

E mail & RDP traffic will be sent / recieved over the vpn.
My question is what is the best way to seperate www traffic from vpn
site to site traffic, at the 2nd location

This should be easy enough to control at your router....I'd set up VPN between two compatible routers/firewalls and not involveWindows in it at all. My usual preference is Sonicwall appliances.




.

Relevant Pages

  • Re: RV042 - Does anyone understand it? Documentation?
    ... if one is using an RV042 for VPN, then what affect does the routing table have on the VPN packets? ... When the packet is received at the other end of the tunnel, it will still be destined for a "foreign" private subnet. ... In other words the range of IP's you are trying to reach and the range of IP's the traffic is coming from MUST be included in the subnets for the encrypted tunnel. ...
    (comp.dcom.vpn)
  • Re: How to use a router provided VPN?
    ... Actually, if both networks are using the same IP network, VPN won't work ... >> a tunnel defined, ... >> opposite subnet, which I can do. ...
    (microsoft.public.windowsxp.work_remotely)
  • Re: Problems w. VPN connection over T-1
    ... This looks like both ends of the tunnel share the same subnet. ... Can you use hardware routers to do the VPN? ... >>> I just setup two networks (one in Cali and the other in Mass). ...
    (microsoft.public.exchange.connectivity)
  • How to use a router provided VPN?
    ... >The DI-804HV can provide encrypted VPN tunnels. ... >a tunnel defined, ... >opposite subnet, which I can do. ... which does it's own encryption. ...
    (microsoft.public.windowsxp.work_remotely)
  • Re: Remote Logon
    ... The tunnel itself is uo and running fine. ... him to utilize our private IP range?? ... That VPN acts as a DHCP gateway and assigns IP addresses to all ... > on the network. ...
    (microsoft.public.win2000.networking)