Re: Routing table question.

Tech-Archive recommends: Fix windows errors by optimizing your registry

Bill,

The servers at either end are not acting as gateways. We have another
router at each site that acts as our internet gateway, and the servers
are the only ones with access to the point to point. I had already
come to the conclusion that I need to add a static route on either end
to kick the 10. traffic to the Cisco routers instead of my internet
gateway, but am not sure how to format the "route add" command. Any
ideas, or could you possibly point me to a better place to get an
answer?

Thanks,
Clay

.

Relevant Pages

  • Re: PPTP Site-to-Site VPN problem
    ... This is true for both servers. ... Each router has a static route to ... that the static routes do *not* have a default gateway set. ...
    (microsoft.public.windows.server.networking)
  • Re: Checkpoint Static Route
    ... packets trying so hard to go where I want them to go despite my lack of ... gateway for all the workstations and servers to the Router. ...
    (comp.security.firewalls)
  • Re: Default router issue
    ... FastEthernet0/1 address via dhcp. ... router of last resort it doesn't show in show run config. ... router is getting its default gateway from the DHCP process. ... servers, default gateways, and tftp servers. ...
    (comp.dcom.sys.cisco)
  • Re: Connection between two servers on different Domain/network
    ... The servers only have to have the router as default gateway and the ... static route on both servers. ...
    (microsoft.public.windows.server.networking)
  • Re: gateway IP address
    ... than one other node connected to the Ethernet so just having one way ... connecting his PC to the router, ... Ethernet is going to be the "gateway". ... This will show how MAC addresses ...
    (comp.dcom.sys.cisco)