Routing table question.



I have a point to point T1 anchored at each end with a Cisco 1720
Router. I also have a T1 line that goes to the internet. The servers
at either end have 2 NIC's each.

Site #1 looks like this:

Internet NIC:
ip 192.168.0.100
mask 255.255.255.0
gateway 192.168.0.1

Point to Point NIC:
ip 10.2.0.4
mask 255.255.255.0
I didn't put a gateway here because I found it caused more problems
and didn't solve any.

Point to Point routers
Site 1: 10.2.0.2 -> 10.0.0.1 -> Site 2: 10.0.0.2 ->10.1.0.2

Site #2 is set up like this.

Internet NIC:
192.168.50.2
255.255.255.0
192.168.50.1

Point to Point NIC
10.1.0.4
255.255.255.0

I know I need to make an entry into the routing tables to make the
point to point traffic use only the 10...etc NIC, but I'm not sure
about the syntax. Any help would be appreciated.

.



Relevant Pages

  • Re: home lan setup suggestions
    ... Router internet config dialog shows: ... Default gateway: xxx.xxx.xxx.N+1, being the IP assigned by ISP ... Modem manages the connection/disconnection to internet, ... The router itself uses the gateway IP given to it by the ISP. ...
    (comp.security.firewalls)
  • Re: Urgent! New router and big disaster
    ... The SBS DNS server, running on ... its IP it means that your problem is now DNS. ... forward ports to it reliably in the router. ... I should have been more clear about internet connection.. ...
    (microsoft.public.windows.server.sbs)
  • Re: Urgent! New router and big disaster
    ... Both NICs should point to his internal IP for DNS. ... forward ports to it reliably in the router. ... I should have been more clear about internet connection.. ...
    (microsoft.public.windows.server.sbs)
  • Re: Missing routing in LAN-WAN routing
    ... Networking, Internet, Routing, VPN Troubleshooting on ... LAN B: 192.168.99.0 Mask 255.255.255.0 ... IP 192.168.99.1 Mask 255.255.255.0 No Gateway ...
    (microsoft.public.windows.server.networking)
  • Re: Urgent! New router and big disaster
    ... First Page of the Internet Connection Wizard, ... Next I Select a local router device with an ip address. ... You should give your SBS a fixed external address so you can forward ports ...
    (microsoft.public.windows.server.sbs)