Help: routing and remote access.

Hello everyone,



I am attempting to connect to sites with routing and remote access. At this
time routing and remote access is configured as a means for NAT for the
networked users under the server and as a vpn/firewall for the network.
Users can vpn into the network and all is stable.

It is setup this way on both servers.

Now I am looking to build a trust relation between the two servers but I
need to have the servers linked.

What is the best way to go about doing this?

Here is some info about the servers and networks:

Note: Both are in remote locations

Server1: IP Address Schema of 10.0.0.0/24

Server2: IP Address Schema of 10.0.100.0/24



What I have done so far is to add a remote router under the 'network
interfaces' in the routing and remote access, assigned network info needed
and then changed to persistent connection as this will need to always be
linked

So far if I start a connection from server1 it connects and I can ping
remote systems on that network.

When I try to get server2 to connect to server 1 it does not work unless I
break the connection from server1 to server2.

I hope someone here can understand what I am trying to do. As I think I am
suck.



I also need the users in each network to see the servers on the respective
servers networks.












.

Relevant Pages

  • Re: Windows 2008 IPv6
    ... Routing is routing, whether you are using vlans or not. ... Like if I have my servers in a seperate VLAN or NETWORK.. ... I'm wondering if my authentication servers are on VLAN1 how do you get users from VLAN2 to authenticate and use services from VLAN1.. ... are capable of VLAN's configure your switches to separate the servers ...
    (microsoft.public.windows.server.networking)
  • RRAS wont start (7024 and 20103)
    ... I have a customer with two W2K SP4 UK Servers, ... Routing and Remote Access running perfectly on it. ... The Routing and Remote Access service terminated with ...
    (microsoft.public.windowsupdate)
  • Re: routing and remote access.
    ... post the routing table here. ... I am attempting to connect to sites with routing and remote access. ... Users can vpn into the network and all is stable. ... Now I am looking to build a trust relation between the two servers but I ...
    (microsoft.public.windows.server.networking)
  • Re: Can not use UNC path in Windows server 2003 server 64 bit OS
    ... Will Routing and remote access help to set up local network ... > You do not need a router. ...
    (microsoft.public.win2000.dns)
  • Re: remote desktop and vpn question
    ... It sounds like your server is not routing packets to the local network make ... sure that in routing and remote access under the properties of your RAS ... Under Adapter select the Network ...
    (microsoft.public.windows.server.general)