Re: Wirless domain network

Sounds like you haven't setup the router correctly for DHCP to give the
Server's DNS adress, or configured DHCP relay to route to the DHCP server
you have everything configured.

Recheck your DHCP configurations.
"dhaven" <dhaven@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:D135EE3A-4511-4687-B9D7-D2B9E4625A78@xxxxxxxxxxxxxxxx
Hi folks, I have an issue with a network we just set up, we have set up a
temporary are for about 30 people, In this room we put two Cisco aironet's
set up for "peap" based on network credentials. The pc's are IBM
thinkcentre's and we are usin belkin 54G usb adapters. the problem is once
the adapteris installed and we setup the ssid and make the necessary
configuration the pc will A) Only use cached credentials B) be very
intermittent with the getting an ip address. If we log in with cached
domain
credentials it will login and work, As soon as we log in with a non cached
account it either hags at the logon screen or doesn't obtain an ip
address.


.

Relevant Pages

  • Re: Broadcast Address as Gateway
    ... > configurations. ... It adds about a half minute to the setup of each host, ... They were going to have the routers configured by DHCP, ... > something that the RFC specifically recommends NOT doing. ...
    (comp.os.linux.networking)
  • [SLE] Looking for a book that describes highly available DHCP setups
    ... it should cover installations with failover and load balancing configurations of dhcpd. ... I searched on O'Reilly's Safari for DHCP books, but found none that covers DHCP failover. ...
    (SuSE)
  • Re: Beware - NetworkManager
    ... servers (which I do have at home behind a router with DHCP disabled), ... will overwrite the configurations for that profile, ... However, at home, I end up disabling NM and then run a shell script which ... but you still need to stop it and change profiles if you sometimes have a ...
    (Fedora)
  • Re: Change DHCP IP Adress
    ... ISP's doesn't effect this, These addresses will not change because the ISP ... > So leave the router the same on the DHCP? ... >> information with our new IP address, gateway, dns servers the users were ... >>> Old Configurations DHCP: ...
    (microsoft.public.win2000.networking)
  • Re: SBS 2003 Networking issues
    ... recommended that I did not use DHCP as part of the setup ... I did a manual setup of the ... I setup the DNS address as being the one on the Server. ... >How did you change the nics and what wizards did you run ...
    (microsoft.public.backoffice.smallbiz2000)