Re: 2nd DHCP Scope?

Hello,

The router is the current gateway. It also connects the 3rd location with a
T1.

What I've done so far is:

Added the static route in the router/gateway.
Added VLAN to the switch and assigned it an IP from the new range.
Created the second scope on the windows 2000 server and activated it.

I can't reach the switch that is plugged into the one above that I added the
VLAN to.

Any ideas?

"Oliver O'Boyle" <ooboyle@xxxxxxxxxxxxx> wrote in message
news:OZY9bskBGHA.4076@xxxxxxxxxxxxxxxxxxxxxxx
>
>
>> I added an IP of the new range to the server and if I connect from the
>> switch at the end with the new IP and perform a ipconfig renew, I
>> receive an IP from the original IP range. If I assign an IP from the new
>> range, I can reach the server and ping the switch, however I can not get
>> to anything on the .4.x network.
>>
>> Does this make since?
>
> sort of... it's a bit confusing. However, if your 2811 is multihomed (or
> has two interfaces, each connected to a separate switch), then it needs to
> do the routing for you, unless you also put the server on the second range
> (might be easier, depending on your particular needs).
>
> If you don't put the server on the second range, then each subnet needs to
> point to the router as the default gw. The router will have a route to
> each range by default, because they are both connected to it.
>
> I'm not sure what else you are using the router for, but it might just be
> simpler to multihome your server. You could put two NICs in it, and have
> it communicate directly on each subnet.
>
> Oliver
>
>>
>> Thanks!!!
>>
>
>


.

Relevant Pages

  • Re: static routing
    ... from the remote server, but not clients. ... It is just one connection between the two routers. ... Each router now has a static route to the subnet at the other site ...
    (microsoft.public.windows.server.networking)
  • Re: static routing
    ... Connections work going out from inside the router, ... I'll have to remove the router and connect the server directly to the cable ... A static route has been added that matches the subnet ...
    (microsoft.public.windows.server.networking)
  • Re: Active Directory New Site
    ... the networks, new subnet object, new site then configure DFS. ... the same server room, appearing to AD as though its remote. ... Switch w/ Replica DFS Store" is a working model or will it just go down like ... Would it be as simple as putting the router between the existing switch, ...
    (microsoft.public.windows.server.active_directory)
  • PPP adapter not getting the gateway entry when router calling in
    ... We are facing a small static route add problem with Win2K ... 2000 will allocate a IP address to the router end and one ... the cisco router LAN) try to ping the remote RRAS server, ... This is due to the gateway issue at PPP adapter, ...
    (microsoft.public.win2000.ras_routing)
  • Re: Home Networking Question: Bridging/IP Forwarding between 2 LAN segments
    ... WAN port to the switch. ... Connect server 6 to the Westell and configure as necessary to allow ... Connect the WAN port on the Linksys router to the Westell device (or ... Linksys LAN ports. ...
    (microsoft.public.win2000.networking)
Loading