I currently have a network setup on the 172.20.4.x IP range.
I need to add another DHCP scope because I am just about out of IPs.
Now, I have configured a second scope on the Windows 2000server and
activated it.
The server is plugged into a Dell 5324 powerconnect with the default VLAN on
the .4.x network.
There is a Cisco 2811 that is the default gateway.
Servers -> PC5324 -> older power connect to be on new range 172.20.9.x
What I believe I need to do is: add a second VLAN on the PC5324 with an IP
from the new IP range. Now, do I need to add a route in the cisco since it
is the gateway?
I added an IP of the new range to the server and if I connect from the
switch at the end with the new IP and perform a ipconfig renew, I receive
an IP from the original IP range. If I assign an IP from the new range, I
can reach the server and ping the switch, however I can not get to anything
on the .4.x network.
Re: ConnectComputer Problem ... I'm a little confused by your network configuration.... Switch2 --- SBS Server...switch has internet access all the time, the second switch has the client ...NICs... (microsoft.public.windows.server.sbs)
Re: RDP Connections - Freeze or Reconnect ... I immediately swapped the connector and cable out and plugged the cable coming out of the switch into the spare 100mb NIC adapter but still using the connector and extra cable. ... The connection of the 100mb LAN from then on appeared much more stable. ... If I logon and test the RDP connection with a dialup modem through RRAS (Terminal server is also a RAS Server), would you expect it to misbehave if it was I switch problem? ... You mentioned seeing a red X on the server's network connection in an earlier post. ... (microsoft.public.windows.terminal_services)
Re: Backup to USB works but to NAS fails ... There is a 30' stretch from the server to a hub (which doesn't have ... Then 3' to the NAS drive.... Can you reduce things down to one decent switch....Poor network throughput, is most commonly, use of cheap 25$ ... (microsoft.public.windows.server.sbs)
RE: Active Directory New Site ... I was warned off the RRAS service for this type of network challenge. ... a new switch with the second redundant server/dfs replica on? ... Sites and Services to create a new site, then inside that, the server object... The piece of equipment you are missing is a router to get you from one ... (microsoft.public.windows.server.active_directory)
Re: Backup to USB works but to NAS fails ... Then 3' to the NAS drive.... If we put another network card in the server we ... Can you reduce things down to one decent switch....Poor network throughput, is most commonly, use of cheap 25$ switches. ... (microsoft.public.windows.server.sbs)
