microsoft.public.windows.server.networking

Hello Everyone.

I seem to have developed a problem after installing SP1. I have two of
these boxes doing the exact same thing. Luckily I'm still in the
pre-production environment.

Before installing Sp1 I have adapter 1 with ip address 90.0.0.153 and
adapter 2 with 90.0.0.53. I reboot the server wait 10 minutes and then
Ping both interfaces from my desktop 0% packet loss on adapter 1 and 2.
I then install sp1. I reboot as requested. I then wait 5 minutes and
ping both adapters again. Adapter #1 fires back with 0% packet loss. I
then ping adapter 2 and end up with 25% packet loss. It appears the
First ping (out of 4) never made it to the destination. So I wait 5
minutes and try again.. Only to be greeted with the same problem. So I
rebooted thinking that may clear the air. And I'm still with the same
problem with the first packet seeming disappearing.

I have been Looking around the Forums / Usenet / etc.. Looking for
possibilities and have come up empty handed. Since this did happen
after installing Sp1 I'm convinced that Sp1 is to blame. Also uninstall
sp1 doesn't fix this issue. ( I've reinstall from scratch 3 times just
to make sure I wasn't screwing something up. Before I did reinstall I
was installing software into this server (it's running terminal
services as well) at one point I was using rdp to get into the machine
yet couldn't connect to a mapped drive, couldn't browse the local
network (via My Computer address bar \\name\share or \\ip\share. A
reboot did make that condition go away but I can't help but think they
are related somehow.

Any Ideas would be greatly appreciated.

.

Relevant Pages

  • I think i did something bad...
    ... Last night I was installing SP1 for XP and after it had ... finished downloading and installing but before I ... Then when I went to reboot the ... the power and starts over. ...
    (microsoft.public.windowsxp.general)
  • Re: XP Pro Service Pack 1
    ... Data should be safe. ... SP1 will need to be reloaded after Repair Installation. ... It is best to resolve current issues BEFORE installing SP1. ... After SP1 install is completed, reboot, defrag. ...
    (microsoft.public.windowsxp.security_admin)
  • Fixed Server 2003 SP1 Problem
    ... After installing SP1 on my Windows 2003 Standard Edition that is doing the ... webserver job something very strange in going on. ... the outside again and ok from the inside; now if I reboot it, ...
    (microsoft.public.windows.server.general)
  • Problem with SHLWAPI
    ... I was installing SP1 on Windows XP Home Edition and lost ... power in the middle of the install. ... When I reboot it will ...
    (microsoft.public.windowsxp.security_admin)