RE: Communicate between subnets

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance



"Matt Laufer" wrote:

> Hello,
>
> We have a pix 515 firewall setup with an inside, outside, and DMZ. Our
> win2k3 webserver is on the dmz on one subnet, and the clients and the win2k3
> ad domain controller along with the clients are on the inside. Machines on
> the inside can connect to the dmz via unc path, but you can not browse to
> them. Mac clients can not connect to them at all.
>
> I have spent countless hours troubleshooting this issue with cisco, and I'm
> starting to think it is something with out windows configuration, possibly
> hostfiles. Any insight would be appreciated.
>
> -Matt
>
>

Hi:

Did you install windows 2003 sp1? I have heard of a similar situation with a
pix firewall where a win2003 machine after having had sp1 installed looses
its default gateway on the interface connected to the pix firewall. It's
driving the IT staff wild. There may be a problem with sp1 for windows 2003
and multiple nics. See dell forum.

http://forums.us.dell.com/supportforums/board/message?board.id=pes_win2003&message.id=2322

.

Relevant Pages

  • RE: [fw-wiz] False results to DMZ
    ... The firewall allows anything IP from this scanner. ... > Using NMAP, If I scan one specific DMZ, I only get results with the SYN ... AND it says every port is open. ... Can you post a sanitized version of your PIX config? ...
    (Firewall-Wizards)
  • ISA firewall
    ... We secure our network with one Cisco PIX 520 firewall, ... I was considering using the Microsoft ISA as the 2nd stage firewall "the one ... between the LAN and the DMZ" ...
    (Security-Basics)
  • Re: Can PIX 501 be VPN terminator inside another firewall?
    ... I don't know if the DMZ is in use, since this firewall is about 50 miles away and my contact there is not in today. ... Will your firewall suppport IPSEC pass thru to the DMZ port? ... PIX to the DMZ port and the other PIX 501 port to yoru ...
    (comp.dcom.sys.cisco)
  • Re: CISCO PIX hard question, can you answer it? TIA
    ... I have a PIX FW, no DMZ, 10 users inside the FW and three servers ... All the servers have static nats from the outside to the inside over ... When a user from inside the firewall attempts to ...
    (comp.dcom.sys.cisco)
  • Ang: RE: Firewall and DMZ topology
    ... Network Engineer ... Subject: Firewall and DMZ topology ... > The Gartner Group just put Neoteris in the top of its Magic Quadrant, ...
    (Security-Basics)