NT 4 to Windows 2003 Server DHCP Problems

Hello,

We currently have a NT 4 acting as a DHCP server and recently setup a
new machine for the DHCP. It was authorized ok but the clients can't
seem to get any IPs. The New server is using a new IP address in the
same subnet.

Yes, the old server has the DHCP services stop and data imported into
Win2K3 according to the KB article (migrating NT4 DHCP to Win2K3)


Any ideas?


thanks

.

Relevant Pages

  • RE: VPN, RRAS & DHCP
    ... Open DHCP console. ... Check the status of the local server. ... <VPN connections subsequently fail again. ... <I say fail but in practice both the server and clients are assigned IP ...
    (microsoft.public.windows.server.sbs)
  • RE: DHCP: not reached by clients
    ... This newsgroup only focuses on SBS technical issues. ... | Thread-Topic: DHCP: not reached by clients ... | thereafter re-enabling dhcp server it worked perfectly. ...
    (microsoft.public.windows.server.sbs)
  • Re: How to setup effective school network
    ... > I have a very nice quality server ... ... > Network card all hubs and switches to my server and serve dhcp. ... the listing it appears you are running samba/windows clients. ... Do SSO for just a few hosts initially to get some experience. ...
    (comp.os.linux.networking)
  • Re: does not match the existing scope error at install!!
    ... I always give a static IP to both NICs after the server portion has finished ... and before I continue with the rest of the SBS setup. ... This DHCP message is popping up before setup even finishes. ...
    (microsoft.public.windows.server.sbs)
  • Re: Taking Domain Controller Offline
    ... Depends of the DHCP clients lease, if you think that the amount of time that ... additional DHCP server, of course if you've one in place you should use it ... sure that the clients are able to use the additional DNS server. ... "Jorge Silva" wrote: ...
    (microsoft.public.windows.server.active_directory)