Re: Analysis still sticks with Local Quorum even Logical Quorum was found
Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance
Does Disk Q: show up in your cluster? Do you have a seperate HBA for your
cluster's shared storage?
Regards,
John
<felixhan@xxxxxxxxx> wrote in message
news:1149228418.587901.149290@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi there,
I just came to a puzzle of setting up a two node clustering as
following the steps by steps guide of Mircrosoft yesterday. The
logical quorum was found in the first time analysis, which I could also
selected the "Disk Q:", but after configured the virtual IP, domain
account and password, the second analysis finished with Local Quorum,
which is C drive, and no drop down selection for me to select again to
Disk Q. From this point on, even I successfully configured the first
node, I wasn't able to join the node because of the quorum.
Can someone tell me where I was wrong in configuration? or any
suggestions? Many thanks!
Felix
.
Relevant Pages
- Re: Split brain scenario in cluster server system
... Whenever the cluster cannot determine who owns the quorum, ... Eachnode in the cluster renews the disk reservation that it owns, ... tries to reserve the quorum disk. ...
(microsoft.public.windows.server.clustering) - RE: Move quorum to new disk
... The procedure for actually replacing the quorum disk is identical to ... required to startup the cluster in the event of a quorum disk failure. ... replacement procedure outlined in Recovering a shared disk to replace the ...
(microsoft.public.windows.server.clustering) - Re: active active windows 2003 clustering
... >>create the cluster, ... During Windows 2003 MSCS analysis the Quorum ... Disk selection process follows Best Practices ... >>cluster install on windpws 2003 server enterprise. ...
(microsoft.public.windows.server.clustering) - Re: Moving a Quorum from the c drive to a San Dsik array
... Once you've presented the disk to both nodes, formatted it, assigned it a drive letter, then you can create it as a new 'Physical Disk' resource in the same group as your MNS resource. ... you can move the quorum designation as Rodney indicated and delete the old MNS resource. ... Microsoft Enterprise Platforms Support (Server Core/Cluster) ... To move the quorum use Cluster Administrator, right click on the Cluster name, go to the Quorum tab, use the disk drop down to select a new disk resource. ...
(microsoft.public.windows.server.clustering) - Re: Changing LUNS
... To test I tried adding this node to another test cluster and it added fine, ... but build it to a minium just add the Quorum disk and no other disks. ... Posting state 2 notification for resource ...
(microsoft.public.windows.server.clustering) |
|
